Figure 6.6.5 - Video Tampering Alarm
2. Check “Enable Video Tampering” checkbox to enable the video tampering detection.
3.Set the video tampering area; refer to Task 1 Set the Motion Detection Area in Section
6.6.1.
4. Click “Edit” to edit the arming schedule for video tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection.
Refer to Task 2 Set the Arming Schedule for Motion Detection in Section 6.6.1.
5. Check the checkbox to select the linkage method taken for the video tampering.
Audible warning, notify surveillance center, send email and trigger alarm output are
selectable. Please refer to Task 3 Set the Alarm Actions for Motion Detection in Section
6.6.1.
6. Click “Save” to save the settings.
6.6.3 CONFIGURING ALARM INPUT
STEPS
1. Enter the Alarm Input Settings interface:
Configuration > Advanced Configuration> Events > Alarm Input
2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO (Normally
Open) and NC (Normally Closed). Edit the name to set a name for the alarm input.
