39
EN
If the message “Empty the two trays” is displayed, empty and clean the drip tray.
1. Remove, empty and clean the coffee grounds collector. Fig. 21.
2. Remove the coffee drawer.
Wait for at least 8 seconds, then first of all put the coffee drawer back in place and then the
coffee grounds collector tray.
Fig. 22.
The drip tray is equipped with a float indicating when it requires emptying. Fig. 23.
Circuit rinsing
You can perform a rinse at any time by pressing Prog then maintenance. Depending on the
types of recipes prepared, the machine can perform an automatic rinse when switching off.
Automatic clean programmes
Automatic clean programme for the coffee circuit
The machine will tell you when a clean programme is required. This clean must take place
every 360 preparations approximately.
To perform the clean programme, you will need a container with a capacity of at least 0.6 l;
this should be placed under the coffee outlets and a KRUPS cleaning tablet (XS3000).
Follow the instructions on-screen. It is also possible to launch cleaning via the maintenance
menu.
Important: you do not have to perform the clean programme immediately when the
appliance requests this; however, you should do this as soon as possible. If
cleaning is delayed, an alert message will remain on the screen until the
operation is performed.
The automatic clean programme includes two phases: a clean and a rinse cycle; the
programme takes about 13 minutes.
Important: if you disconnect your machine during cleaning or in the event of a power
cut, the cleaning programme will resume the stage in progress during the
incident. It will not be possible to delay this operation. It is mandatory due to
water circuit rinse reasons. In this case, a new cleaning tablet may be
required. Make sure the entire clean programme is completed to remove any
traces of descaling product that may be hazardous to your health.
Do not place your hands under the coffee outlets during the cycle.
Automatic descale programme for the steam circuit
Caution: if your appliance is fitted with our Claris - Aqua Filter System cartridge, please
remove this before descaling.
The machine will tell you when the descale programme is required. The frequency at which
this programme needs to be run depends on the quality of the water used and whether the
Claris Aqua Filter System filter is used or not (the more limescale in the water, the more
descaling is required).
Important: you do not have to perform the descale programme immediately when the
appliance requests this; however, you should do this as soon as possible. If
descaling is delayed, an alert message will remain on the screen until the
operation is performed.
!
!
!
!
