36
To remove any trace of milk from the steam spout, place a container under the spout and press
"hot water" for a few seconds.
The steam spout can be disassembled for thorough cleaning. Fig. 14.
Wash with water and a bit of non-abrasive washing up liquid using a brush. Rinse and dry. Fig.
15.
Before putting back into its place, make sure that the air holes are not blocked with milk residue.
Unblock with the needle provided if necessary. Fig. 16.
SUPER CAPPUCCINO ACCESSORY (available depending on model)
Important: we recommend that you use pasteurised or UHT milk, recently opened.
Unpasteurised milk does not produce the best results.
The
super cappuccino accessory helps the preparation of a cappuccino or latte.
Preparing the appliance:
Connect the milk suction pipe to the
super cappuccino accessory, on the unbevelled side. The
inlet must not be twisted.
Fit the accessory on the steam outlet.
Enter the bevelled end of the suction pipe into a container filled with milk. Fig. 17.
Place a cup under the
super cappuccino accessory.
Recipe stage 1:
Select the cappuccino ( ) or caffè latte ( ) position on the super cappuccino accessory.
Press “steam” to launch the pre-heating.
Possible settings
You can change the steam time using the – and + buttons located to the left and right of the
symbols.
Press the “OK” button on the touch screen to launch the preparation.
Important: press any button to stop the steam function. Caution, the cycle does not stop
immediately.
Recipe stage 2:
Place a cup under the coffee outlet and start a coffee/espresso cycle. Fig. 18. (See chapter:
Preparing drinks using coffee beans).
Rinsing the accessory:
To ensure that the accessory functions correctly, rinse with water after each use. Your appliance
will not ask you to do this.
Carry out a steam cycle with a container filled with water in order to
clean the accessory on the inside.
Fig. 19.
To do this, you can also use the KRUPS liquid cleaner which is available as an accessory.
Maintenance and cleaning:
Remove the super cappuccino accessory and clean the parts using a small brush and, if
appropriate, with a little washing-up liquid.
Pay particular attention to cleaning the part circled in
the photo. Fig. 20. The hole in the metal part should not be allowed to become blocked.
!
!
