11
2 - First rinsing
A first rinsing is needed to eliminate the remaining scale remover.
This cycle is run automatically. It lasts about 6 minutes.
± 6 mn
Empty your receptacle
full of waste water.
Empty the drip tray and
then put it back again
together with the
receptacle as
previously.
Empty, clean and rinse
the water tank and then
fill it again up to the
“Max. level.
Replace your water
tank. The ‘calc’ light will
flash and the light
will go off.
Press the ‘Service’ key.
The ‘calc’ light will
become steady. The
automatic cycle will last
6 minutes.
Once the second
rinsing is finished,
the ‘calc’ light will
go off.
Again press the
‘Service’ key. The
‘calc’ light will
become steady.
A second automatic
cycle will last 6
minutes.
Empty the drip tray and
then fit it again.
Empty and then fill
your water tank.
3 - Second rinsing
At the end of the first rinsing, the ‘calc’ light will flash.
A second automatic cycle will last 6 minutes.
Your appliance is now ready for use again.
Remove your waste
water recipient and the
drip tray then fit them
again.
If there is not enough water in the water tank, you will be warned by the light.
Add the appropriate amount of water to the tank and scale removal will continue automatically.
If a power failure occurs during the cycle, you will have to start it up again from the start.
± 6 mn
LONG RINSING PROGRAM
Remove, fill and replace
the water tank.
When the cycle has completed, the ‘water tank’ and ‘calc’ lights blink.
Under the coffee out-
lets and steam nozzle
place a recipient that
can contain at least
0.15 L.
Launch the long rinse pro-
gram by pressing on the
"Service" button.
The "clean" and "calc"
lights stop blinking.
+
When the long rinsing
program is complete,
the "clean" and "calc"
lights turn off
Be sure to complete the entire scale removal cycle to avoid any risk of intoxication.
The scale removal cycle is a continuous cycle. Do not put your hands under the coffee outlets
during the cycle.
