5. Insert the speaker into the cutout hole. With a #2 Phillips screw-
driver, tighten the four dog clamps until they are seated securely
against the ceiling surface. Do not overtighten.
6. For installations using the 70/100V input connection, set the
switch on the front panel to the desired tap setting. For applica-
tions where16 Ohm impedance is desired, the switch should be
set to 16 Ohms. Note: The speaker comes from the factory set at
the lowest output setting (highest impedance).
7. The IC-5T and IC-6T feature a ±15 degree swivel tweeter
to aim high frequency sound to a desired location. To aim
sound directly at the listening area, gently adjust the horn to
the desired angle.
8. Using the flat of your hand, insert grille into speaker frame
making sure it is securely seated and flush.
Seismic Tab
A seismic tab, located on the back of the speaker, is used
as a secondary security point. Some construction codes
may require its use. To utilize the seismic tab, run a support
wire from a secure point in the ceiling and attach it to the
tab. Be sure to consult the construction codes in your area.
Klipsch recommends the use of this tab in all installations as
a secondary means of support.
