ķ℀ĸ
11
Assembling Your 4
1
⁄2 Quart Mixer
TO ATTACH BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Tilt motor head back.
3. Place bowl on bowl clamping plate.
4. Turn bowl gently in clockwise
direction.
5. Plug mixer in proper electrical outlet.
**
TO REMOVE BOWL
1. Be sure speed control is OFF and
mixer is unplugged.
2. Tilt motor head back.
3. Turn bowl in counterclockwise
direction.
TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
1. Turn speed control to OFF and
unplug.
2. Raise motor head.
3. Slip beater onto beater shaft and
press upward as far as possible.
4. Turn beater to
right, hooking
beater over pin
on shaft.
5. Plug mixer in proper electrical outlet.
**
TO REMOVE FLAT BEATER,
WIRE WHIP OR DOUGH HOOK
1. Turn speed control to OFF and
unplug.
2. Press beater upward as far as
possible and turn left.
3. Pull beater from beater shaft.
4. Plug mixer in proper electrical outlet.
**
TO LOCK MOTOR HEAD
1. Make sure motor head is completely
down.
2. Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
TO UNLOCK MOTOR HEAD
1. Place lever in UNLOCK position.
NOTE: Motor head should always
be kept in LOCK position when
using mixer.
TO OPERATE SPEED CONTROL
Plug mixer in proper electrical outlet.
**
Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of bowl.
See page 14 for Speed Control Guide.
St. Joseph, Michigan
