14
1. The machine is factory-set to make coffee with a standard taste. You can choose coffee with the
following tastes: extra-mild, mild, standard, strong or extra-strong, with the option of using pre-ground
coffee. To choose the desired taste, press the button (B3) (Figure 8) repeatedly until the required
taste is displayed.
2. Place 1 cup under the coffee spouts if you wish to make 1 coffee (Figure 9) or 2 cups for 2 coffees
(Figure 9). For a creamier coffee, lower the coffee spout as near as possible to the cups (Figure 10).
3. Press button (B4) (Figure 11) to select the type of coffee desired: espresso, small cup, medium
cup, large cup, mug.
Press button (B8) (Figure 12) to make 1 coffee, or button (B9) (Figure 13) to make 2 coffees.
The machine grinds the coffee beans and then runs off the coffee.
After running off the pre-set quantity of coffee, the machine automatically stops run-off and then
empties the coffee grounds into the grounds container.
4. After a few seconds, the machine is once again ready for use.
5. To switch off the machine, press the on/stand-by button (A7) (Figure 1). (Before switching off, the
machine runs an automatic rinse cycle: beware of the danger of burns).
N.B.:
• If coffee run-off is too slow or incomplete, refer to chapter ADJUSTING THE COFFEE GRINDER.
• If coffee run-off is too quick and the coffee is not creamy enough, refer to chapter ADJUSTING THE
COFFEE GRINDER.
• Tips for hotter coffee:
- proceed as described in chapter CHANGING AND SETTING MENU PARAMETRS, function Rinsing;
- do not use very thick cups as they absorb too much heat unless pre-heated in advance;
- use pre-heated cups, rinsing them with hot water.
• You can interrupt run-off any time by pressing the previously selected button again.
• As soon as run-off is finished, to increase the amount of coffee in the cup, simply press and hold the
previously selected button within 3 seconds of completion of run-off).
• When the display shows FILL TANK! the water tank must be filled, otherwise the machine will not
prepare any coffee. (The tank may still contain some water; this is normal).
• Every 14 single coffees (or 7 doubles) made, the display shows the message EMPTY GROUNDS
CONTAINER!. To clean, open the service door on the front by pulling the spout (Figure 16), then
remove the drip tray (Figure 17) and clean it.
When cleaning the machine, always fully remove
the drip tray.
• When removing the drip tray, the grounds
container MUST be emptied. If this is not
done, the machine may clog up.
• The water tank must never be pulled out during
coffee run-off. If the tank is removed at this
point, the machine cannot make the coffee and
will display the message: GROUND TOO FINE.
ADJUST MILL! PRESS 'OK' followed by FILL
TANK!. Check the water level in the tank and
replace in the machine. To restart the machine,
insert the water spout if not already inserted
(Figure 6), press (B7) and the display shows HOT WATER. PRESS 'OK'. Press (B7) within a
few seconds, let water run off from the spout for around 30 seconds. After run-off, the machine display
automatically reverts to the programmed standard settings.
• The machine may require you to repeat the operation several times; this is in order to eliminate any air
in the hydraulic circuit.
• If the above described operation is not carried out correctly or if the machine is switched off, the
display may revert to showing the programmed standard settings, even if in actual fact the problem
persists.
Making coffee (using coffee beans)
