1414
Control panel lock - BASIC
Locking/activating Control panel lock:
Pressing the Control panel lock button in standby or active mode locks the keypad; the
stylized key symbol lights up. The control continues to operate in the previously set mode
but can no longer be controlled by other buttons, except by the Control panel lock button or the ON/OFF
button. Switching off with the ON/OFF button is also possible when locked. The Control panel lock button
LED switches off when the Touch control and Control panel lock function are switched off. The LED
lights again if reactivated (within 10 sec.) until it is deactivated by pressing the Control panel lock button
once again. The activation/deactivation of the Control panel lock function is not possible in the OFF mode.
Unlocking/ deactivation of the Control panel lock - BASIC
Pressing the Control panel lock button again in standby or active mode unlocks the keypad and the stylized
key symbol turns off. All sensor buttons can be pressed again.
Control panel lock - EXTENDED
The Control panel lock can be activated after turning on the Touch pad by simultaneously pressing the area
selection button in the lower right (3A) and the MINUS (5) button and then pressing the area selection
button in the lower right area (3A) again. There will be an “L” , meaning LOCKED (Control panel lock
feature against unintended switching-ON). If a cooking zone is in the “hot” condition, “L” and “H” will be
displayed in alternation. This course of operation has to take place within a period of 10 seconds, no other
key than described above may be operated. Otherwise the input will be interrupted because of
incompleteness, the cooktop will not be locked then. The electronic control remains in a locked condition
until it gets unlocked, even if the control has been switched-OFF and -ON in the meantime. Also a reset of
the control (after a voltage drop) does not cancel the key lock.
Partial unlock of the buttons for cooking:
To unlock the Touch pad simultaneously press the cooking area selection button in the lower right (3A) and
the MINUS (5) button. “L“ (LOCKED) in the display extinguishes and all cooking zones show “0“ with a
blinking dot. Should a cooking zone be “hot”, “H” is displayed instead of the static “0”. After switching-
OFF the control, the Control panel lock feature is active again.
Permanent removal of the key lock:
After switching-ON the control the Control panel lock feature can be deactivated. You must simultaneously
press the cooking area selection button in the lower right (3A) and then press the MINUS (5) button alone.
If all steps have been carried out in the right order within 10 seconds the key lock gets cancelled and the
control is OFF. Otherwise the input will be considered incomplete, the control remains locked and
switches-OFF after 20 seconds.
After a renewed switching-ON by means of the ON/OFF key all displays show „0“, the display dots are
blinking and the control is ready for cooking. If a cooking zone is “hot“ , “H“ will be displayed instead of
the static „0“.
Booster and induction power management
The cooking area B has a Booster function that goes from 1400 to 2000 W (during this power increase, the
power of cooking area A is reduced). The generator, with Booster On, gives the cooking zone power that is
significantly greater than the rated output. The booster allows a particularly rapid heating of the food
thereby saving the user time.
The Booster function can be activated as follows:
- The cooking zone must be at the maximum possible level;
- The Booster function is activated by pressing the “+” button again. A fixed “P” is displayed on the
indication of the cooking zone.
For safety reasons, the Booster function for each cooking zone can only be activated for a limited time of 5
minutes. If the pan is removed from the cooking zone during the Booster time, the Booster function
remains on and also the Booster time is not deactivated.
The Booster is switched off by pressing the “-“ button. The “+” has no effect whatsoever.
Instructions for use
