Connection to the mains gas system must be
carried out by a competant, registered
person, in compliance with current legislation.
• The connection of the hob to the gas mains
network or gas cylinder must be done using a
rigid copper or steel pipe with parts that
comply with local standards, or using a flexible
stainless steel pipe with continuous surfaces that
comply with local standards. The flexible
metallic pipe should be no longer than 2 linear
metres.
• Before connecting the pipe with the rubber part
(A), ensure that seal (B) is in place (this part,
provided complies with EN549).
Warning: if you use a stainless steel flexible pipe, it
must be installed in such a way that it does not
come into contact with mobile parts like drawers
or kitchen cupboards and passes at a point free of
obstacles where it can be examined in its entirety.
• After connecting to the gas mains, use soap and
water to check there are no leaks.
9
Technical information for the installer
• This appliance can be built into a 20mm to
40mm thick worktop.
• If no oven is to be installed below the hob, a
panel must be fitted under the hob to prevent
hob damage and protect the cupboard contents.
This panel must cover the whole of the
underside of the hob and must be positioned so
that an air gap of at least 20mm between the
panel and hob underside is maintained, as a
minimum, and as a maximum 150mm to the
underneath of the work surface.
• This hob is designed to operate perfectly with
any oven in the KitchenAid range. The
Manufacturer declines all responsibility should
any other make of oven be installed.
The manufacturer declines all responsibility
should another make of oven be installed.
Before installation, please ensure that:
•Warning: this is a heavy products which
requires the installation to be carried out
by two people.
• The gas supply (type and pressure) and the
calibration on the hob are compatable ( see
serial number plate on the hob and the table on
page 6).
• The cabinetry and appliances surrounding/next
to the hob rea heat resistant and in compliance
with local regulations.
• The products of combustion are removed from
the atmoshere in the room by using an
extraction hood or electrical fan installed to the
walls and or windows, in line with current
regulations.
• The air circulates naturally through a suitable
opening that is no less than 100cm2in cross
section, which must be:
- perminent and accessable on the walls of the
room being ventilated and extracting towards
the outside.
- created in such a way that the openings both
inside and out cannot be obstructed, even in
error.
- Protected by plastic grill, metallic netting etc
that should not reduce the 100cm2cross section
- Located in such a position so as not to
interfere with the extraction of the products of
combustion.
Installation
Gas connection
