8
2. Screw the fastening bridge of the machine in the position of the drawing.
3. Screw the fastening flanges of the drainage hoses.
4. Place the machine on the support angles of the guides. Adjust the width before fastening the screws
checking that it slides softly along the path.
Connections to the Water Network
Use the flexible pipe with the two filter joints supplied with the machine. Pressure should be between 1
and 5 Bar.
If pressures overpass such values, install the necessary corrective devices.
Leave free the needed length to extract the machine up to the end of the guides.
The rest can be flanged and gathered at a side to avoid that when storing the machine it can touch the
water pump and stop it or make noise.
Connection to drainage
The drainage must be in the position established in the drawing. In the left part of the housing and below
the inferior level of the machine. In this way the flexible pipes have the enough path to allow the
extraction of the machine.
It is convenient that the drainage pipe has an entry with an interior diameter of 50 mm to introduce the
two drainage hoses of the machine.
Fix the pipes with the flanges that were provided. Thus, we ensure that when taking out and storing the
machine, the pipes do not come out.
