TO ATTACH FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Slip flat beater on beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater over
the pin on shaft.
TO REMOVE FLAT BEATER,
WIRE WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Press beater upward as far as possible
and turn left.
• Pull beater from beater shaft.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of
bowl. See “Speed Control Guide.”
OVERLOAD RESET BUTTON
(Model 5KPM50 only)
• If the mixer is overloaded, the Overload
Reset Button will pop out and the mixer
will shut off. Turn the Speed Control
Lever to OFF. Wait a few minutes, then
push in the Overload Reset Button. Turn
the Speed Control Lever to the desired
speed and continue mixing.
English
R-7
TO ATTACH BOWL
• Be sure speed control is OFF.
• Place bowl lift handle in down position.
• Fit bowl supports over locating pins.
• Press down on back of bowl until bowl
pin snaps into spring latch.
• Sit pouring shield on bowl.
• Raise bowl before mixing.
NOTE: Check that bowl and pouring shield
are properly in place (5KPM5 models).
TO REMOVE BOWL
• Place bowl lift handle in down position.
• Grasp bowl handle and lift straight up
and off locating pins.
TO RAISE BOWL
• Rotate handle back and up until it snaps
into the locked vertical position.
• Bowl must always be in raised, locked
position when mixing.
TO LOWER BOWL
• Rotate handle back and down.
