English
11
Adjusting for Maximum
Grind Fineness
Adjusting the grinder to provide
maximum fineness will slightly decrease
the grind sizes throughout the grinding
range. (To adjust the unit to provide
coarser grinds, see page 10.)
1. Empty the bean hopper, then
run the grinder a few seconds to
clear any remaining beans from
the machine.
2. Turn the grind control dial to
level “8”.
3. Using a 4 mm wrench, remove
the screw located in the front of
the grind control dial by turning it
counter-clockwise. Hold the grind
control dial so that it does not
rotate as the screw is removed.
Once the screw is free, remove the
grind control dial.
The white grind control gear should
be visible once the grind control dial
is removed.
4. Turn on the unit
by flipping the
“O/I” Switch to the “I” position.
5. Rotate the grind control gear
clockwise 1 “click” or detent at a
time until you hear the burrs
touching one another – when they
touch, the burrs will make a distinct
“rubbing” or grating sound.
6. When the burrs are touching,
turn the grind control gear
counter-clockwise 1 “click” or
detent. The grating or “rubbing”
sound will stop. Turn off the
grinder by flipping the “O/I”
Switch to the “O” position. The
grinder is now calibrated to
provide maximum fineness.
7. Re-attach the grind control dial,
making certain the dial indicator
points to grind level “8”.
NOTE: If the burr grinder produces a
grating or “rubbing” sound during
use, the burrs have been improperly
adjusted. Damage to the burrs will
result. Readjust the burrs
immediately.
Adjusting the Cutting Burrs
