8
SXRC Remote Control
Installation
Mounting
DIN Mounting
Using the supplied hardware you can mount the SXRC into a
standard DIN sized opening.
Be sure you will have a minimum of 2”
(51 mm) clearance depth behind your mounting
surface panel to mount the SXRC.
If not using an existing DIN opening, you will first need to cut
an opening that is 7-3/16” (182 mm) by 2-1/8” (53 mm) into your
mounting surface panel.
It is VERY important that you DO NOT make the hole any
larger than the specified dimensions. If you make the opening too
large then the mounting cage will not work properly.
Using the existing DIN opening or
the one you just created, slide the
Metal DIN Mounting Cage into the
opening. Secure the Cage by bending
the Mounting Tabs on the sides, top
and bottom of the Cage using a small
flat-blade screwdriver. Use only the
tabs that when bent will secure the
Cage to the Mounting Surface.
Next, place the Plastic Cosmetic Trim Ring into the Metal DIN
Mounting cage. There are two plastic retainers in the Trim Ring
(one on top and one on bottom) that will snap into place.