772982
57
Verklein
Vergroot
Pagina terug
1/82
Pagina verder
MY20K10-02_1.0_10.11.2020 57
Cleaning and servicing
7.4 Maintenance
The following maintenance measures must be
performed on a regular basis.
7.4.1 Wheel
1Check the tyres for wear.
2Check the tyre pressure.
3Check the rims for wear.
The rims of a rim brake with invisible wear
indicator are worn as soon as the wear
indicator becomes visible in the area of the rim
joint.
The rims with visible wear indicator are worn as
soon as the black, all-round groove on the pad
friction surface is no longer visible. We
recommend that you also replace the rims with
every second brake lining replacement.
4Check the tension of the spokes.
7.4.1.1 Checking the tyres
Check the tyre wear. The tyre is worn if the
anti-puncture protection or the carcass cords
are visible.
A specialist dealer will need to change the tyre
if it is worn.
7.4.1.2 Checking the rims
Check the rims for wear. The rims are worn as
soon as the black, all-round groove on the pad
friction surface becomes invisible.
Contact your specialist dealer to have the rims
replaced. We recommend that you also replace
the rims at the same time as every second
brake lining replacement.
7.4.1.3 Checking and adjusting the tyre
pressure – Dunlop valve
Only applies to S pedelecs with this equipment
The tyre pressure cannot be
measured on the simple Dunlop
valve. The tyre pressure is
therefore measured in the filling
hose when pumping slowly with
the bicycle pump.
It is recommendable to use a
bicycle pump with a pressure
gauge. The operating instructions
for the bicycle pump must be
adhered to.
1Unscrew and remove the
valve cap. Connect the bicycle pump.
2Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
3Correct the tyre pressure according to
specifications in the S Pedelec pass.
4If the tyre pressure is too high, unfasten the
union nut, let air out and re-tighten the union
nut.
5Remove the bicycle pump.
6Screw the valve cap tight.
7Screw the rim nut gently against the rim with
the tips of your fingers.
Crash and falling caused by unintentional
activation
There is a risk of injury if the drive system is
activated unintentionally.
Remove the battery before maintenance.
Crash caused by braking hard on rims
A rim can break and block the wheel if you brake
hard. This may cause a crash with serious
injuries.
Check rim wear on a regular basis.
Notice
If the tyre pressure is too low in the tyre, the tyre
does not achieve its load bearing capacity. The
tyre is not stable and may come off the rim.
If the tyre pressure is too high, the tyre may burst.
Check the tyre pressure as per specifications.
Adjust the tyre pressure as necessary.
CAUTION
!
WARNING
!
57

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kettler Velossi 2.0 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kettler Velossi 2.0 in de taal/talen: Engels als bijlage per email.

De handleiding is 7.33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Kettler Velossi 2.0

Kettler Velossi 2.0 Gebruiksaanwijzing - Nederlands - 82 pagina's

Kettler Velossi 2.0 Gebruiksaanwijzing - Deutsch - 83 pagina's

Kettler Velossi 2.0 Gebruiksaanwijzing - Français - 84 pagina's

Kettler Velossi 2.0 Gebruiksaanwijzing - Espanõl - 85 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info