• Pedalling
Decreases with presetting.
• The presetting entries are lost with a “Reset”.
Training interruption/end of training
With less than 14 pedal rotations per minute, the electro-
nics assembly of the device identifies a training interrupti-
on. The achieved training data are displayed. Rotations,
pulse and speed are displayed as average values with the
symbol Ø.
You can switch to the current display using “Plus” or
“Minus”.
The training data are displayed for four minutes. If you do
not press any key nor train during this period of time, the
electronics assembly of the device switches to sleep mode.
Resumption of training
If you resume training within four minutes, the last values
continue to be increased or decreased.
RECOVERY function
Recovery pulse measurement
Press “RECOVERY” at the end of training.
Display
• RECOVERY
The electronics assembly of the device measures your
pulse 60 seconds in reverse.
The current pulse value is saved under “DISTANCE”; the
pulse value after 60 seconds is saved under “KM/H”.
Next to “% Puls”, the difference between the two values is
displayed. From this difference, a fitness mark (in this
example F 1.6) is calculated. The display switches off
after 20 seconds.
“RECOVERY” interrupts the recovery pulse function or the
fitness mark display.
If no pulse is measured in the beginning or at the end of
the reverse counting, the error message “E” is displayed
Comment:
Training and Operating Instructions
18
GB
