RECOVERY function
Recovery pulse measurement
Press “RECOVERY” at the end of training.
Display:
REC
The pulse value is stored (P1).
The current pulse is still displayed.
The electronics assembly of the training device measures
your pulse 60 seconds in reverse.
The pulse value after 60 seconds (P2) is stored.
The pulse difference (P1-P2) is displayed
From this value, a fitness mark (F 4.8 for this example) is
determined.
The display is completed after 20 second.
“RECOVERY” interrupts the recovery pulse function or the
fitness mark display.
If no pulse is measured in the beginning or at the end of
the reverse counting, the error message “Err” is displayed.
Display of previous training with average
and maximum values
• Press “Persons”: selection of persons
Display:
“Person 1 flashes, total training time and kilome-
tres”
• Switch persons using “Plus” or “Minus”
• Press “Persons” once more:
Display:
Average values of pulse, % pulse, RPM, km/h and
brake level of the previous training are displayed with
the [Ø] symbol.
• Press “DISP/SET”
Display:
Average values of pulse, % pulse, RPM, km/h and
brake level of the previous training are displayed with
the [MAX] symbol.
• Press “DISP/SET”
Display:
Readiness for training with or without presettings.
The last training values only refer to the previous training
unit. The values are stored by “RESET” or by the activation
of the stand-by mode with time display deleting previous
values.
Comment:
FB601/610
19
GB
actual pulse
fitness mark
(P1- P2)
Pulse after 60s
(P2)
Pulse REC Start
(P1)
Display of max. va-
lues [MAX]
Display of average
values [Ø]
