15
GB
UT6886/UT6887
• Pressing “MODE” stops and starts the display change.
• When defaults are reached for time, distance and
Kjoule/Kcal
(0-values), brief signal tones are output and the bottom display
areas flash. From now, the values count upwards again.
• If the input pulse value is exceeded, the bottom pulse display
flashes as a warning.
Interruption or End to Training
If there are fewer than 15 cadences/min, the electronics detects
that training has been interrupted. STOP SCAN is shown in the
display and the training data is displayed in rotation.
→ RPM or SPEED → TIME → DISTANCE →Kjoule/Kcal→ PULSE →
ODO → etc.
• Pressing “MODE” stops and starts the display change.
The training data is displayed for 4 minutes. If you do not press
any buttons or train in this time, the electronics switches to
standby mode and displays the time.
An interruption to training is detected with a delay of a few
seconds.
Resuming Training
If you continue the training within 4 minutes, the
last values continue counting or count downwards.
RECOVERY Recovery pulse stage
The RECOVERY function can be used after each exercise
program.
The RECOVERY button is used to initiate recovery pulse
measurement at the end of exercising. Initial and final pulse
during one minute are used to calculate deviation and a fit-
ness score. In case of equal exercising, improvement of such
score is a measurement for increase of fitness.
When reaching the target values, end exercising and press
the RECOVERY button; then, leave your hands at the hand
pulse sensors. In case of previous pulse measurement, the
display shows 00:60 for time, and the PULSE display shows
the current pulse value (flashing). The countdown starts at
00:60. Leave your hands at the hand pulse sensors until the
countdown reaches >0<. The display will show on its right a
value between F1 and F6. F1 is the best status; F6 is the
worst status. The function can be ended by pressing again
RECOVERY.
If no pulse is measured in the beginning or at the end of the
reverse counting, the error message “Err” is displayed.
Comment:
