English
— 40 —
The following messages are displayed when certain problems are occurring in your system. Take the
recommended actions.
Nothing has been recorded on the MD.
BLANK
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
]
]
EJECT
No tracks are recorded on the MD, although it has a title.
NO TRACK
The unit is malfunctioning for some reason.
Press the reset button on the unit. If the "E- 77", code does not disappear, consult your nearest service centre.
]
E-77
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
Check the disc magazine. And then, press the reset button on the unit.
If the "E- 99" code does not disappear, consult your nearest service center.
]
E-99
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F),
stopping all operation.
Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F),
the disc starts playing again.
]
HOLD
If this indicator continues blinking, it is possible that the tape has become jammed or tangled.
Contact the Kenwood dealer if the tape cassette cannot be ejected.
]
IN
No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
The CD is very dirty. The CD is upside-down. The CD is scratched a lot.
Clean the CD and load it correctly.
]
]
E-04
No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
]
NO DISC
Troubleshooting Guide
The faceplate of the slave unit being connected to this unit has been removed.
Replace it.
]
NO PANEL
