683161
174
Verklein
Vergroot
Pagina terug
1/196
Pagina verder
Antenna Output for External Receivers
When this function is ON, the RX signal that enters the transceiver
from the currently selected antenna (ANT 1, ANT 2 or RX ANT) is
split along the way. A part of the split signal is input to the RX circuit,
while the other part to the ANT OUT terminal.
Press and hold [RX ANT] to set the antenna output
for external receiver to ON or OFF.
When it is ON, << >> lights up.
When the antenna output function is used, the RX
sensitivity and gain lower by approximately 3 dB due to
signal loss in the splitter.
During transmission, there is a very slight amount of
output leakage due to internal isolation (approximately
-20 dBm in the 50 MHz band).
The ON/OFF status of the antenna output function is
stored separately for the HF band and 50/70 MHz band.
Emergency Call (K Type Only)
Section 97.401(d) of the regulations governing amateur radio in
the United States permit emergency amateur communications on
5167.5 kHz by stations in or within 92.6 km of the state of Alaska.
This frequency is for use only when the immediate safety of human
life and/or property are threatened, and is never to be used for
routine communications.
Press [EMERGENCY] to change to the Emergency channel
(5167.5 kHz/ USB).
[EMERGENCY] can be assigned to a PF key.
When entering Emergency mode, EMERGENCY
momentarily appears on the screen.
RIT/XIT turns OFF automatically when entering
Emergency mode.
The transceiver will not switch to the Emergency channel
if you are using the constant recorder and are either
transmitting, receiving a voice call, or receiving a CW
call.
Crossband Repeater
If you have a KENWOOD FM transceiver (K type) with a 6 pin mini
DIN connector, you can set up the TS-890S transceiver and the
FM transceiver as a crossband repeater. The FM transceiver will
receive signals you transmit from the additional VHF or UHF
transceiver when both transceivers are set with the same
frequency. The signal is then routed to the TS-890S transceiver
and retransmitted on the frequency you have set on the TS-890S
transceiver. Likewise, signals received on the TS-890S
transceiver are routed to the FM transceiver and retransmitted to
the transceiver you have with you, allowing you to hear the
received call in a distant location.
For the repeater function to operate, the squelch levels
of both transceivers (TS-890S and FM transceiver) must
be adjusted properly so that no background noise can
be heard; the transmission is controlled by monitoring
the squelch status only.
Connection
.
TM-D700A
TM-D710GA/
TM-D710A/
TM-V71A
TS-890S
PR1
SQC
PKSPSQ
PKD
PKS
ANI
ANO
16 OTHER FUNCTIONS
16-16
174

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood TS-890S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood TS-890S in de taal/talen: Engels als bijlage per email.

De handleiding is 21,11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Kenwood TS-890S

Kenwood TS-890S Gebruiksaanwijzing - Nederlands - 196 pagina's

Kenwood TS-890S Gebruiksaanwijzing - Deutsch - 196 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info