683161
154
Verklein
Vergroot
Pagina terug
1/196
Pagina verder
This transceiver does not support IPv6.
This transceiver supports ping and other ICMP
responses.
The Ethernet standard used on this transceiver is
100BASE-TX. Use a commercially available cable that
is Category 5 (Cat5) or higher.
When connecting to a hub or broadband router, make
use of a commercially available straight cable.
Turn off the power of this transceiver and the device to
connect to before connecting the cable.
Even when the IP address is acquired automatically, IP
address cannot be configured in an environment where
a DHCP server is not used.
When the IP address is acquired automatically, the IP
address, subnet mask, default gateway, primary DNS
server and secondary DNS server are grayed out and a
parameter cannot be input.
When an IP address is automatically acquired and
configured for this transceiver, the configured IP address
is displayed in the IP address setting.
Setting DHCP to ON updates the parameter. If an
address is not acquired, the address field will remain
blank.
The address may not be acquired immediately after
DHCP is set to ON.
Even when the IP address is configured while DHCP is
OFF, this IP address will be displayed when DHCP is set
to ON.
Viewing the MAC Address
The MAC address of this transceiver which is necessary for its
operation via LAN can be identified in this menu item.
Check LAN Menu [6]
MAC Address.
The MAC address of this transceiver can be identified here.
This menu item is intended for viewing only, and the setting in
LAN Menu [6] MAC Address cannot be altered.
KNS Operation
KNS (KENWOOD NETWORK COMMAND SYSTEM) is a
collective term that refers to the system for remotely operating a
KENWOOD transceiver via the network such as the Internet or
LAN. Operation using this system is referred to as “KNS
operation”.
The ARCP-890 and other related programs for remote
operations, and “TS-890S KENWOOD NETWORK
COMMAND SYSTEM Setting Manual” can be
downloaded from the URL below.
http://www.kenwood.com/i/products/info/amateur/
software_download.html
This manual describes only the explanation on the areas
of the transceiver configuration. For details on specific
configurations, please refer to “TS-890S KENWOOD
NETWORK COMMAND SYSTEM Setting Manual”.
System Configuration Overview
Basic Configuration for Remote Operation through the Internet
To operate the TS-890S remotely through the Internet using KNS,
configure the system as shown in Figure 1.
.
TS-890S
Remote PC with
ARCP-890
LAN
Connection
Broadband
Router
Broadband
Router
Internet
Figure 1: Basic System Configuration
Under this configuration, the TS-890S performs login authentication
of the remote user (administrator and registered user) operating the
ARCP-890, followed by control command communication after
authentication is complete. Voice communication is carried out by
the TS-890S and ARCP-890 via the built-in VoIP.
Administrator refers to the owner of or person in charge
of managing the transceiver. Registered user refers to a
user other than the administrator who is authorized to
operate this transceiver remotely via KNS. A registered
user needs to be registered in advance by the
administrator to the KNS users list in the TS-890S.
Configuration when Using ARVP-10 or a Non-
KENWOOD VoIP for Voice Communication
When using ARVP-10 or a non-KENWOOD VoIP application
software program for voice communication, configure the system
as shown in Figure 2.
.
TS-890S
Voice
Host PC
VoIP Application
Remote PC with
ARCP-890
VoIP Application
LAN Connection
Hub
Broadband
Router
Broadband
Router
Internet
Figure 2: System Configuration when Using a Non-
KENWOOD VoIP Application
Under this configuration, voice communication between the
remote PC and host PC is carried out using the ARVP-10 or a non-
KENWOOD VoIP application software.
Voice communication between the host PC and the TS-890S is
carried out using the USB audio function (via USB cable
connection) or by extracting analog audio output signal (ANO) and
analog audio input signal (ANI) from the ACC 2 connector,
followed by connecting to the audio input/output connector of the
PC sound card. The configuration of components other than that
for voice communication are the same as the basic configuration.
15 NETWORK/KNS OPERATION
15-2
154

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood TS-890S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood TS-890S in de taal/talen: Engels als bijlage per email.

De handleiding is 21,11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Kenwood TS-890S

Kenwood TS-890S Gebruiksaanwijzing - Nederlands - 196 pagina's

Kenwood TS-890S Gebruiksaanwijzing - Deutsch - 196 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info