606692
85
Verklein
Vergroot
Pagina terug
1/96
Pagina verder
77
INSTALLING OPTIONS 14
SO-3 TCXO
The SO-3 option improves the transceiver frequency
stability to ±0.5 ppm.
1 Remove the CN503 connector and TCXO PCB
screw, as shown below.
TCXO PCB
CN503
TCXO PCB
CN503
2 Remove the TCXO PCB.
3 Insert the SO-3 TCXO.
Align the SO-3 TCXO adjustment hole with the
“O” on the TCXO PCB.
4 Solder all pins on the reverse side of the PCB.
5 Re-insert the TCXO PCB in the transceiver.
6 Connect the CN503 and tighten the screw.
7 Move the C903 and C904 jumper as shown below.
CN903
CN904
TC501
Note:
To avoid misplacing the jumper, keep it attached to 1 pin of
C903 or C904.
When removing the SO-3 TCXO, replace the jumper to its
original position.
8 Replace the bottom case (10 screws).
REFERENCE FREQUENCY CALIBRATION
Note: The transceiver is adjusted at the factory prior to shipping.
Do not perform this adjustment unless it is necessary.
1 Set the following on the transceiver:
• Mode: CW
AF control: Center
Menu No. 40 (CW RX pitch): 800 Hz
SHIFT control: 800 Hz
RIT function: OFF
Break-in function (VOX): OFF
2 Remove the bottom case (10 screws) from the
transceiver.
3 Tune in a standard frequency station such as WWV
or WWVH at, for example, 10.000.00 MHz or
15.000.00 MHz.
• Adjust the Tuning control so that the display
reads the exact frequency of the station.
You should hear a beat tone of approximately
800 Hz.
For 800 Hz:
f
af
= (f
display
/15.600 x f
reference
) + 800 Hz
where f
reference
is the shift from the 15.6 MHz
reference frequency.
4 Close your CW key. You will hear a transmit
sidetone of approximately 800 Hz.
This sidetone produces a double beat tone
when it combines with the received signal.
• Adjust the AF control to hear the double beat
clearly.
For 800 Hz:
f
sidetone
= 800 Hz ±50 ppm (= 800 ±0.04 Hz)
where f
reference
is the shift from the 15.6 MHz
reference frequency.
5 TS-590SG transceiver without SO-3:
Adjust the trimmer (TC501) to minimize the
frequency difference between the received 800 Hz
tone and the 800 Hz sidetone.
TS-590SG transceiver with SO-3:
Adjust the trimmer inside the SO-3 using the
supplied plastic adjustment tool. Minimize the
frequency difference between the received 800 Hz
tone and the 800 Hz sidetone.
85

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood TS-590SG bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood TS-590SG in de taal/talen: Engels als bijlage per email.

De handleiding is 4,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Kenwood TS-590SG

Kenwood TS-590SG Gebruiksaanwijzing - Nederlands - 96 pagina's

Kenwood TS-590SG Gebruiksaanwijzing - Deutsch - 96 pagina's

Kenwood TS-590SG Gebruiksaanwijzing - Français - 96 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info