Recalling your sound settings:
Press a preset button (#1-6) except during the bass center
frequency, bass level, bass quality factor, bass extension,
treble center frequency, and treble level adjust mode.
This mode is available only when Sound coordinate system is on.
(page33)
NOTE
Storing your sound settings:
Hold down a preset button (#1-6) for two seconds or more.
• This setting can be made only when the Sound coordinate
system is on.( page33)
• The settings you can preset are, bass centre frequency, bass
level, bass quality factor, bass extension, treble centre
frequency, and treble level.
NOTE
"V OFFSET" : Set the sound level of the each source selected by
adjusting the level difference between the basic
sound level and the required level.
Setting values: - 8 – 0
Function of the KRC-PS978R/KRC-878R
"NF PHS" : Adjust the phase for Non-Fading output.
Setting values: NOR (0°) / RVE (180°)
• This mode is available only when the non-fading output function
is set to on.( page9)
• Not available during the Dual zone system is on.
NOTE
Function of the KRC-PS978R/KRC-878R
"LPF" : Adjust the frequency of the Low-pass filter for Non-
Fading output.
Setting values: 50 Hz / 80 Hz / 120 Hz / Through
Function of the KRC-PS978R/KRC-878R
"HPF R" : Adjust the frequency of the High-pass filter for rear
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
• You can separately set the high-pass filter for front and rear
output, including preouts.
• The high-pass filter does not affect the non-fading preout
(KRC-PS978R only).
• The high-pass filter works except during non-fading preout
when switching to non-fading.(KRC-878R only)
• The factory default settings for front output and rear output are
"Through" .
NOTE
Function of the KRC-PS978R/KRC-878R
"HPF F" : Adjust the frequency of the High-pass filter for front
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
• You can separately set the high-pass filter for front and rear
output, including preouts.
• The high-pass filter does not affect the non-fading preout
(KRC-PS978R only).
• The high-pass filter works except during non-fading preout
when switching to non-fading.(KRC-878R only)
• The factory default settings for front output and rear output are
"Through" .
NOTE
— 13 —
• This mode is available only when the non-fading output function
is set to on.( page9)
• Not available during the Dual zone system is on.
NOTE
