— 40 —
English
Removing the hard rubber frame
■
When the lower level is removed, remove the upper two
locations.
2
The frame can be removed from the top side in the same
manner.
NOTE
Catch
Lock
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
1
Accessory2
Removal tool
Installation
Screwing the Faceplate on the Unit
■
Never insert the taptite screws (ø2.6 × 12 mm) in any other
screw holes than the one specified. If you insert it in another
hole, it will contact and may cause damage to the mechanical
parts inside the unit.
2CAUTION
If you want to fasten the faceplate to the main unit so that it
does not fall off, insert the provided screw (ø2.6 × 12 mm) in the
holes as follows.
Insert one of the
provided screws into
hole
1 so that the
screw is perpendicular
to the bottom panel of
the unit.
Similarly, insert another
provided screw into
hole
2.
Ensure that the faceplate is fixed firmly before operating this
unit.
2
1
Bottom panel
Hole1
Hole2
Accessory7