DT ISTR_6541091_04/21 15/60
• In case you leave the appliance unused for a long time, isolate the burner (i.e. by using a plastic bag) in
order to avoid the insects’ nest-building and the dusting for which the manufacturer doesn’t take the
responsibility.
• To clean the injector and the duct of the pilot flame, remove the
protective metal mesh. On the right side of the valve, in a steel
tube of about 1 cm in diameter, is located a small copper tube
curved. Unscrew the retaining screw, remove the copper tubing
and blow compressed air inside the steel tube.
• It may be necessary to clean the brass injector mounted on
copper tubing, but this should only be performed by qualified
personnel.
• Heat the brass injector with a lighter to melt the glue.
• After this operation, the injector will be hot and then unscrew it
with pliers or gloves.
• Clean the injector with liquid detergent (can be used detergent
for flooring), rinse with running water and dry it by blowing
compressed air.
Screw the injector by applying a drop of sealing fillets or loktite
on the thread of copper tubing.
• CAUTION: Do not exceed with the seal fillets because abundant
drippings of liquid could clog the injector hole again.
Reassemble everything pushing up the injector in order to pass
the locking screw that, once screwed without tightening
exaggerated, will only keep the injector into the correct position.
• If necessary, contact the assistance office.
