631710
9
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
9
Operate the system from your vehicle‘s battery (12 V) or a suitable
mains power pack. This mains power pack must guarantee a stable
initial voltage of 12 V, 11 A continuous current and 15 A (300 ms) surge
current.
The transient power consumption is up to a maximum of 12 A.
To ensure reliable functioning of the connecting/control unit, the power
supply cable must be connected directly to the battery. If the power
supply is too low, the UFD 170 /UFD 540 receiver indicates this with
the on-screen message “On-board voltage too low” on the television
screen.
A 15 A fuse is integrated into the power supply cable.
If the fuse responds, the source of the fault must be eliminated and the
defective fuse replaced with a fuse of the same rated value (15 A).
Power supply, fusing
Never remove or bridge the fuse in the cable – cable re hazard!
The UFD 170 (on the front side) and the HDS 160 (in the connection
area on the back side) have a removable 10 A at fuse.
If the fuse responds, the source of the fault must be eliminated and the
defective fuse replaced with a fuse of the same rated value.
Connecting the power supply cable wire marked “Ignition” to
the ignition circuit activates the turntable function for automatic
lowering of the antenna. This lowering takes place as soon as the
vehicle ignition circuit is turned on.
When connecting the control unit to the on-board network, it must
be ensured that the “+12V”, “Earth” and “Ignition” wires cannot be
broken by switches connected in series, as this can deactivate the
automatic lowering function.
The antenna lowers after max. 12 seconds after the switching on
of the vehicle ignition circuit (if in stand-by and if the UFD 170
is switched off, otherwise the control unit lowers immediately in
operation).
Safety instructions - important notes
Checks before commencing a journey
Before commencing a journey, the antenna must always be lowered
into horizontal position (park position). If the antenna has collided
with xed or moving objects, you must check that is still securely
tted.
As the antenna is subjected to vibration loads during driving, at
regular intervals, depending on the frequency of driving, you should
check that the system is still securely tted and tighten any parts that
have come loose.
The maximum permissible speed for vehicles with a BAS 60
receiver unit mounted on the roof is 130 km/h.
Lower the antenna if it will not be used for a long period. This makes
the securing bolts more dif cult to access (protection against theft).
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kathrein CAP 210 - MobiSet 2 digital bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kathrein CAP 210 - MobiSet 2 digital in de taal/talen: Engels als bijlage per email.

De handleiding is 1,96 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Kathrein CAP 210 - MobiSet 2 digital

Kathrein CAP 210 - MobiSet 2 digital Installatiehandleiding - Nederlands - 40 pagina's

Kathrein CAP 210 - MobiSet 2 digital Installatiehandleiding - Français - 36 pagina's

Kathrein CAP 210 - MobiSet 2 digital Installatiehandleiding - Espanõl - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info