804777
11
Verklein
Vergroot
Pagina terug
1/140
Pagina verder
English 11
Operation
Function
The water first flows from the water inlet through the
combination filter (for a description of the filter, see
chapter Consumables). Depending on the button
pressed, the water then flows through the cooling mod-
ule or directly to the water dispenser outlet. The entire
water system must be cleaned chemically at regular in-
tervals.
Operation
Note
The illuminated sensor buttons are activated by a light
touch.
Illustration G
1"Chilled water" button
2"Unchilled water" button
1. Place a container in the middle of the drip tray.
Illustration H
2. Press the button for the desired type of water until
the container is full.
During this process, the pressed button lights up
brighter.
Shutting down
If the unit is not used for more than 4 days:
1. Close the water inlet.
2. Switch off the unit.
Initial startup after decommissioning
WARNING
Health risk due to increased germ concentration
Perform chemical cleaning after decommissioning.
1. Switch the device on.
2. Open the water inlet.
3. Dispense at least 2 litres of each type of water and
discard the water.
4. Carry out chemical cleaning (see chapter Chemical
cleaning)
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
Do not transport the device in a horizontal position.
When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.
Equipment shipping
The device must not be transported in a horizontal posi-
tion.
Select a suitable packaging for transport and mark it
on the outside with a conspicuous marking for verti-
cal transport.
If possible, place a small wooden pallet under the
shipping box.
Alternatively, take the device directly to a Kärcher
service centre.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
1. Store the device in a frost-protected place.
Care and service
WARNING
Health risk due to improperly repaired device
Have the device repaired only by trained specialist per-
sonnel.
Before performing any work on the unit:
1. Pressure relief of the unit.
a Close the water inlet.
b Place a container under the water dispensing
opening.
c Press the “Chilled water” button until no more wa-
ter is dispensed.
2. Switch off the unit.
3. Pull out the mains plug.
Replacing the filter
WARNING
Health risk through the entry of germs
When installing the filter cartridge, take special care to
ensure hygiene and cleanliness.
Always wear sterile disposable gloves when installing
the filter.
1. Close the water supply inlet.
2. Press the "Chilled water" button until no more water
is dispensed.
3. Open the filter cover latch.
4. Remove the side filter cover.
5. Remove the filter to be replaced.
Illustration I
a Pivot out the filter with the filter holder by max.
45°.
b Unscrew and remove the filter.
6. Unpack the new filter.
7. Insert the new filter.
Illustration J
a Fit the filter into the filter holder and turn it as far
as it will go.
The filter is locked.
b Pivot the filter with the filter holder into the device.
8. Fit the side filter cover.
9. Close the filter cover latch.
10. Plug the mains plug into the socket.
11. Place a container under the water dispenser.
12. Open the water inlet.
13. Press the "Chilled water" button repeatedly until a
rinsing time of 5 minutes has been reached (approx.
10 - 15 litres).
Note
The device automatically stops dispensing after 60 sec-
onds of continuous water dispensing.
14. Carry out chemical cleaning (see chapter Chemical
cleaning).
Chemical cleaning
CAUTION
The outlet water is cleaning water
The dispensed cleaning water is not suitable for con-
sumption.
Chemical cleaning must be carried out after initial start-
up and generally at least every 6 months. The same ap-
plies after a shutdown of more than 4 days or an excep-
tional filter change. The cleaning kit is required for
chemical cleaning (see chapter Consumables).
Note
The chemical cleaning process takes approx. 45 min-
utes.
1. Close the water inlet.
2. Press the button for “chilled water” until no more wa-
ter comes out.
3. Switch off the unit.
4. Remove the combination filter (see chapter Replac-
ing the filter).
5. Insert the service cup.
Illustration K
a Swivel out the filter holder by max. 45°.
b Insert the service cup.
c Turn the service cup clockwise.
d Swivel the filter holder into the unit.
6. Remove the water inlet line.
7. Prepare the cleaning kit.
Illustration L
1Water inlet
2Injector screw connection
3Sealing ring
4Injector housing
5Water outlet (connection on unit)
a Screw the cleaning kit apart.
b Insert the 4 cleaning tabs in the cleaning kit.
c Screw the cleaning kit together taking the correct
seating of the sealing ring into account.
8. Connect the cleaning kit to the unit input.
9. Connect the water inlet line to the cleaning kit.
10. If possible, bring the cleaning kit into a vertical posi-
tion.
Illustration M
11. Remove the drip tray.
12. Place a suitable container with a capacity of at least
1 litre under the water outlet.
13. Plug the mains plug into the socket.
14. Open the water inlet.
15. Switch the unit on.
Note
Carry out the following steps extremely carefully to en-
sure the greatest possible effectiveness of the chemical
cleaning.
Note
The cleaning agent used for chemical cleaning is
equipped with a blue colour indicator. The colouration of
the water that is output indicates the concentration and
effectiveness of the cleaning agent.
Note
A small amount of foam is created during the cleaning
process. This is caused by the system and is normal.
16. Perform cleaning.
a Press the “Chilled water” button until the unit
stops dispensing water after 60 seconds.
b Wait 60 seconds for the detergent to dissolve.
c Repeat this process (rinse for 60 seconds and
wait 60 seconds) a total of two times.
d Empty the receptacle after each rinsing process.
e Press the "Unchilled water" button for 30 sec-
onds.
The rinsing process is complete. The detergent’s
contact time starts. It should be at least
15 minutes and can be extended as required.
f Wait at least 15 minutes for the detergent to take
effect.
17. Close the water inlet.
18. Press any button until no more water is dispensed.
19. Switch off the unit.
20. Remove the cleaning kit.
21. Reconnect the water supply hose to the unit.
22. Remove the service cup and reinsert the filter.
Rinse after chemical cleaning
Note
You can briefly interrupt the rinsing process at any time,
e.g. to empty the rinsing cup.
1. Place a suitable container with a capacity of at least
1 litre under the water outlet.
2. Open the water inlet.
3. Switch the unit on.
4. Press the “Chilled water” button until the blue colour
is no longer visible.
5. Then rinse at least another 4 litres.
6. Press the “Unchilled water” button until the blue col-
our is no longer visible.
7. Then rinse at least another 2 litres.
The unit is ready for operation.
Sampling
To be able to test the effectiveness of the chemical
cleaning, samples should be collected immediately after
completion of chemical cleaning under observance of
the rules for microbiological water analysis and these
should be evaluated by an accredited laboratory.
Emptying the drip tray
The float signals that the drip tray is full. A red marking
ring on the float becomes visible when the maximum fill-
ing level has been reached.
Illustration N
1. Carefully remove and empty the full drip tray.
2. Check the drip tray daily for soiling, clean if neces-
sary.
3. Reinstall the drip tray.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Karcher WPD 50 - Water Dispenser bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Karcher WPD 50 - Water Dispenser in de taal/talen: Alle talen als bijlage per email.

De handleiding is 6.86 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info