– 6
Illustrations on fold-out page!
Illustration
Snap the suction hose hub into the suction open-
ing.
For removal, compress the latch and pull off the
suction hose hub.
Illustration
Connect handle and suction tube and insert.
Connect the floor nozzle and telescopic suction
pipe and insert.
Illustration
Use the adjustment of the telescopic suction pipe
and adjust the telescopic suction pipe to the de-
sired length.
Illustration
For parking or during short breaks, hook the floor
nozzle into the park bracket at the rear of the unit.
Illustration
Hold the mains cable on the plug and pull it out. In-
sert the mains plug into a socket.
Illustration
Turn on the machine.
Illustration
The power suction adjustment is at the power suc-
tion control:
- Suction control open, little suction power
- Suction control closed, high suction power
Adjust the suction power to suit the suction require-
ment:
Low suction power – for laced curtains, textiles,
upholstered furniture, cushions
Medium suction power – for slightly dirty carpets/
carpeted floors, precious carpets.
Highest suction power – for hard floors, very dirty
carpets and carpeted floors
Empty dust container when the marking -MAX- is
reached at the latest.
See Chapter "Emptying the dust container".
Important notice!The appliance will shutdown auto-
matically, if there is danger of overheating. Turn the ap-
pliance off and pull the power plug. Ensure that the floor
nozzle, the telescopic suction pipe or the suction hose
is not clogged or check if the filter must be changed. Af-
ter the elimination of the disturbance, allow the appli-
ance to cool down for a at least 1 hour; then the appli-
ance is ready for operation again.
Furniture brush: for cleaning furniture and deli-
cate objects with care, dusting books, air vents in
the car, etc.
Crevice nozzle: for edges, joints and heaters
Illustration
Insert the handle in the desired accessory until the
stop.
Note: The accessories can also be used when the tele-
scopic suction pipe is attached.
Illustration
Carpets and carpeted floors:
Select the following switch setting:
Illustration
Hard surfaces:
Select the following switch setting:
* depending on model
Used to vacuum sensitive and smooth floors (par-
quet, marble, terracotta etc.).
Illustration
Turn off the appliance and disconnect the mains plug.
Illustration
Push the take-up cable button. The cable will pull it-
self automatically into the appliance.
Illustration
Hang the floor nozzle on the backside of the appli-
ance into the parking holder, and push into the
pause position.
Hold the appliance at the carrying handle when you
want to transport it and store it in dry rooms.
Note: It is recommended that you first completely
push in the telescopic suction pipe.
ATTENTION
– Before working on the appliance, switch it off and
pull out the plug of the vacuum cleaner!
– Only use the device when all filters and the dust
container are installed.
Otherwise the motor can get damaged.
– Defective filters and filters that can no longer be
cleaned must be replaced.
Illustration
Empty dust container when the marking -MAX- is
reached at the latest.
Illustration
Push the lock and remove the dust container.
Illustration
Hold the dust container over a dust bin.
Operate the locking lever.
As soon as the dust container is empty, close the
cover, the lock snaps into place.
Place
the dust container
into the device and snap it
into place.
Note
Ensure the correct seating of the dust container upon in-
sertion.
Operation
Start up
Suction using accessories
Using accessories
Replace the Accessories
Floor nozzle
Reversible floor nozzle
Parquet nozzle
Finish operation
Transport, storage
Cleaning and care
Emptying the dust container
