724918
13
Verklein
Vergroot
Pagina terug
1/156
Pagina verder
English 13
Installation
Note
The handle is installed only once. The handle halves
may not be separated again after installation. Take care
to ensure that the water hose and the mains cable are
not crushed during installation.
1. Plug the handle sections together. The pipe latches
audibly into place.
Illustration B
2. Press the water hose and then the mains cable into
the cable channel from the top to the bottom (start-
ing at the hand grip).
Illustration C
3. Press any protruding cable and water hose firmly in-
to the brush head casing.
Illustration D
The mains cable and water hose must not protrude out
of the device during operation!
Initial startup
1. Close the water volume regulation valve.
Illustration H
2. Connect the water hose to the device. The coupling
must audibly engage.
3. Secure the water hose to the hand grip using Velcro
tape to provide strain relief.
Illustration E
4. Connect the water hose to the water tap and open
the water tap. Please observe the maximum water
pressure (see "Technical data").
5. Connect the mains cable to a suitable extension ca-
ble labelled as conforming to protection class IPX4.
Please be sure to observe the safety instructions.
Operation
Correct handling of the brushes
Note
Use only the brushes suitable for the surface to be
cleaned.
Observe the following instructions for correct use of the
brushes.
1. Position the brushes evenly on the surface to be
cleaned.
Illustration F
2. Guide the brushes over the surface with light pres-
sure.
Switching on the device
Note
You must unlock the power switch in order to start the
device. The specified sequence must be adhered to
1. Press the unlocking button.
Illustration G
2. Press the power switch.
The device starts up.
3. Release the power switch.
The device stops.
Water volume regulation valve
Note
The volume of water emitted by the device through the
nozzles can be adjusted using the water volume regula-
tion valve to suit the cleaning task.
1. Pull the valve lever backwards to increase the water
volume.
2. Push the valve lever forwards to decrease the water
volume or close the valve completely.
Illustration H
Cleaning wooden surfaces
Use the brush for wooden floor coatings for cleaning
wooden surfaces.
Note
Test the device on an inconspicuous area before us-
ing on sensitive surfaces, e. g. wood.
Do not allow it to remain in one area, but keep it in
motion.
Note
Always clean wooden surfaces in the direction of the
grain. Always clean along the floorboards or wooden el-
ements and down the slope.
Note
Pre-treatments may be removed from pre-treated sur-
faces. Uneven light-dark effects result from the type of
wood or its treatment. It is a desirable result to remove
the film on weathered wooden surfaces.
1. Guide the device slowly over the surface.
Illustration I
Apply a suitable care agent or preservative after
cleaning for optimum results!
Cleaning stone surfaces
Use the brush for stone coverings for cleaning stone
surfaces in outside areas (not included in the scope of
delivery - see the Accessories and spare parts chapter
for sources).
Note
Remove any loose elements such as gravel before
cleaning.
1. Guide the device slowly over the surface.
Storing the device
Illustration J
The device can be stored hanging on a wall hook. You
can also alternatively place the device on the parking
edge of the spray guard. Take care to ensure that the
device does not stand on the brushes to prevent dam-
age to the bristles.
1. Disconnect the connections.
2. Empty the device (see "Frost protection").
3. Clean the device (see "Cleaning").
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
Frost protection
ATTENTION
Danger of frost
Incompletely emptied devices can be destroyed by
frost.
Completely empty the device and accessories.
Protect the device from frost.
1. Store the device in a frost-protected place.
13

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Karcher-PCL4

Zoeken resetten

  • Hij werkt tegen en zou zonder inspanning vooruit moeten gaan, is hier een knopje voor Gesteld op 27-2-2021 om 13:21

    Reageer op deze vraag Misbruik melden
    • bij mij werkt hij ook tegen ! het is precies of de borstels in de verkeerde richting draaien. normaal zou ik verwachten dat hij u vooruit trekt. wat doe ik verkeerd ? Geantwoord op 26-4-2023 om 14:27

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Karcher PCL4 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Karcher PCL4 in de taal/talen: Alle talen als bijlage per email.

De handleiding is 15,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info