10 English
Vehicle tyres or tyre valves are suscepti-
ble to damage from the high-pressure jet
and may burst. The first indication of this
is a discolouration of the tyre. Damaged
vehicle tyres/tyre valves are highly dan-
gerous. Ensure that a distance of at least
30 cm is observed when cleaning with the
jet!
Never draw in fluids containing solvents or
undiluted acids and solvents! This in-
cludes petrol, paint thinner and heating oil.
The spray mist thus generated is highly in-
flammable, explosive and poisonous. Do
not use acetone, undiluted acids and sol-
vents as they are aggressive towards the
materials from which the appliance is
made.
ṇ Warning
The mains plug and the coupling of an ex-
tension cable must be watertight and must
never lay in the water.
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this
purpose and labelled with a sufficient ca-
ble cross-section: 1 - 10 m: 1.5 mm
2
; 10 -
30 m: 2.5 mm
2
Always fully unroll electrical cables from
the cable drum.
High-pressure hoses, fixtures and cou-
plings are important for the safety of the
appliance. Only use high-pressure hoses,
fixtures and couplings recommended by
the manufacturer.
This device is not intended for use by per-
sons (including children) with reduced
physical, sensory or mental abilities or
lacking experience and/or knowledge, un-
less they are supervised by a person re-
sponsible for their safety or are instructed
by these persons on the use of the device.
Children should be supervised, to ensure
that they do not play with the device.
The operator must use the appliance cor-
rectly. When working with the appliance,
he must consider the local conditions and
pay due care and attention to other per-
sons, in particular children, who are near-
by.
Do not use the appliance when there are
other persons around unless they are also
wearing safety equipment.
Wear protective clothing and safety gog-
gles to protect against splash back con-
taining water or dirt.
Caution
Observe a distance of at least 30 cm when
using the jet to clean painted surfaces to
avoid damaging paintwork.
Never leave the appliance unattended
when it is in operation.
Make sure that the power cable or exten-
sion cables are not damaged by running
over, pinching, dragging or similar. Protect
the power cable from heat, oil, and sharp
edges.
All current-conducting parts in the working
area must be protected against jet water.
The appliance may only be connected to
an electrical supply which has been in-
stalled in accordance with IEC 60364.
The appliance may only be connected to
alternating current. The voltage must cor-
respond with the type plate on the appli-
ance.
The maximum tolerable mains impedance
at the electrical contact point (see Techni-
cal Data) must not be exceeded.
For safety reasons, we recommend that
you operate the appliance only via a earth-
leakage circuit breaker (max. 30 mA).
Cleaning operations which produce oily
waste water, e.g. engine washes, under-
body washes, may only be carried out us-
ing washing stations equipped with an oil
separator.
This appliance was designed to be used
with detergents which are supplied or rec-
ommended by the manufacturer. The use
of other detergents or chemicals may
compromise the safety of the appliance.
