726290
32
Verklein
Vergroot
Pagina terug
1/524
Pagina verder
- 11
Troubleshooting
DANGER
Risk of injury! The main switch of the vacuum cleaner is to be switched off or the Cekon plug must be unplugged while carrying out
any repairs or maintenance jobs.
Fault Possible cause Remedy of whom
Machine is not running; indi-
cator lamp for operations
stand-by (F) is not glowing
There is no voltage in the machine. Check electrical mains. Electrician
Safety time switch is on. Switch off the appliance switch briefly and
switch it on again.
Operator
Fuse in the control circuit (F3) has
burnt off. Fuse is located in the con-
trol transformer (T2).
Install a new fuse; if it burns out again, then
remove the cause for the over-loading.
Customer Service
Pressure switch HP (High pres-
sure) or LP (Low pressure) is defec-
tive.
Check pressure switch. Customer Service
Timer module (A1) defective. Check connections, replace if required. Customer Service
Exhaust thermostat (B8) tripped. Allow plant to cool down. Unlock the exhaust
thermostat (B8). Eliminate the cause for the
disturbance.
Customer Service
+ Indicator lamp for engine
over-heating (G) is glowing
Thermal sensor (WS) in the engine
or the over-current protection
switch (F1) has got activated.
Rectify cause for over-loading. Customer Service
The water shortage safeguard in
the swimmer tank has got activat-
ed.
Remove the water shortage. Operator
Burner does not ignite or the
flame glows off during opera-
tion
Thermostat (B) has been set at a
very low temperature.
Set the thermostat to a higher level. Operator
Machine switch is not positioned to
burner
Switch on the burner. Operator
The water shortage safeguard in
the safety block has got switched
off.
Ensure adequate water supply. Check ma-
chine for leaks.
Operator
The indicator lamp Burner
failure (E) glows*
Fuel tank empty. Refill fuel. Operator
Fuel filter choked. Clean fuel filter - to do that remove the fuel fil-
ter by turning, clean it and again turn it in.
Operator
Photo-cell flame monitoring device
has been set wrongly or is defec-
tive.
Check the correct positioning of the photo-
cell. **
Operator
No ignition spark exists (can be de-
tected through the sight glass in the
burner lid).
Check electrodes distance between ignition
transformer and ignition cable. Rectify the dis-
tance or replace defective parts. Clean it, if
necessary.
Customer Service
Ignition motor is locked. Removing the blockage. Remove the stopper
(I) on the operating plan and unlock the over-
current protection switch. Insert back the
stopper.
Customer Service
Failure of the fuel pump or the fuel
solenoid valve.
Check parts and replace defective parts. Operator
*
Note: Switch the system off and on to unlock the burner fault.
**
32 EN
32

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Karcher HDS 12-14-4 ST bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Karcher HDS 12-14-4 ST in de taal/talen: Alle talen als bijlage per email.

De handleiding is 17,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info