Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10 TKG GW 900 - 180713
Assembly page 10/39
❑ Never move the appliance by pulling the cord. Make sure the cord
cannot get caught in any way. Stand the appliance on a table or
flat surface. Do not wind the cord around the appliance and do
not bend it.
❑ If your type of appliance has a separate base or a detachable
cord, remove them from the water cooker when filling it. If your
appliance has a fixed cord, unplug it before filling it.
❑ For cooking or warming up please only use cold or lukewarm
drinking water or liquid potations (e.g. mulled wine). Never use
water taken from bath tubs, wash basins or any other containers
in order to protect your own health.
❑ Always fill between the minimum and maximum marks. The water
must never be below the minimum mark or the heating element
might be damaged. Do not overfill the jug kettle as boiling water
might overflow.
❑ When using the appliance, make sure the lid is closed correctly.
Never raise the lid when the jug kettle is in use and when there are
risks of hot water projection due to the bubbling.
❑ Be careful not to get burned by the hot steam that evaporates
when the water is boiling and especially when you open the lid.
❑ Use only the base that is supplied with the jug kettle.
❑ Please note: Should the symbol be indicated on a certain
surface, you need to be careful when handling the product. This
symbol means: CAUTION, this surface may get very hot during
use.
The symbol is always put on the surface with the highest
temperature, however the other metallic or non-metallic surfaces
can also become very hot during use and it is therefore advisable
to always handle them with care and if possible with the help of
isothermal gloves or other thermal protection. In case of doubt
concerning the temperature of a certain surface it is always
preferable to protect oneself.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
