22 Original User Manual | Pedelec Impulse 2.0 Ergo
pends on the current battery charge state and the as-
sist mode which has been set (ERGO, POWER, SPORT
or ECO).
7.2.4 Units
Press and hold the
button for three seconds to switch
between kmh (speed)/ km (remaining range indicator) and
mph/mi.
7.3 Programming and settings
Aer switching on the Impulse system, you can switch
om the main menu to the menu sub-items, by pressing
the button for three seconds.
This takes you to the menu sub-items:
• Drive data
Chapter 1.2.1
• Delete trip data Chapter 7.3.2
• Delete overall data Chapter 7.3.3
• Device settings Chapter 7.3.4
• Personalize Chapter 7.3.5
• Target cost Chapter 7.3.6
• ERGO settings Chapter 7.3.7
• Back
You can select the menu sub-items using the
/ buttons
on the control unit. Conrm your selection by pressing the
button. The respective contents are then displayed for
you. To return to the main menu display om the menu
sub-items, you must select “Back” and conrm by press-
ing the button. You can also return to the main menu by
pressing and holding the button for three seconds.
7.3.1 Drive data
The following data are displayed in the menu sub-item
“Drive data”:
• Trip (in km)
• Trip time (in 00:00:00)
• Trip max (in km/h)
• Trip Ø (in km/h) = Trip average
• Trip cost (in €)
• Tour (in km)
• Tour Ø (in km/h) = Tour average
• Tour cost (in €)
• Overall (in km)
• Overall savings (in €)
• Tot. sav. CO2 (in kg)
• Back
7.2.2 Battery charge state indicator
The battery charge state indicator is located at the top
right of the display. Using a battery symbol divided into
seven segments, it shows the charge remaining in the
battery. The lower the charge state of the battery, the
fewer segments are displayed.
DISPLAY BATTERY CHARGE STATE
-.%
.-.%
.-.%
.-.%
.-.%
.-.%
If the battery charge state falls below a minimum level,
the motor assistance switches o. Then the entire display
fades and goes o, too.
If you do not use your Pedelec for ten minutes, the
system switches o automatically. If you then want
to ride using the assistance, you will have to switch it
back on via the control unit.
7.2.3 Remaining range indicator
Below and to the right of the battery charge state indica-
tor, the distance in km over which you can still travel with
power assist is displayed. This is the remaining range
indicator.