705170
46
Verklein
Vergroot
Pagina terug
1/51
Pagina verder
Page | 46
Can ERGO work with two sets of speakers?
Yes, ERGO can switch between A and B speakers via its front-panel controls. Each set of speakers will need to be calibrated and
will have their own correction filters so that when you are comparing or “A/B’ing” a mix, the specific correction for the selected
monitors is engaged.
Can ERGO work in a 2.1 system?
Yes, ERGO will work with and correct 2.1 systems. It will treat the subwoofer as part of the monolithic speaker system.
Can ERGO work in a 5.1 system? Can I use 2 or more ERGOs for this?
No, ERGO is designed for Stereo or 2.1 (Stereo augmented by subwoofer) only.
Is there a way to bypass the Digital to Analog converters on ERGO so I can use another D/A converter?
No, ERGO uses phase accurate FIR filters in both, the correction algorithm and the D/A converters. FIR filters, unlike IIR filters
found in some D/A converters, do not exhibit frequency dependent phase shifts. Since ERGO corrects in both time (phase) and
frequency domains, it is imperative that we know the characteristics of the D/A converter and do not induce unwanted or
variable phase distortions. Hence the reason behind ERGO's architecture.
Does ERGO color/change the character of my monitors?
No, ERGO only corrects it for presentation in your listening space, just as the character of your mix would change if your
environment was acoustically treated. ERGO performs a similar job, but in the digital domain.
What do the different LEDs on the Focus/Global button indicate?
When the button is illuminated ERGO is in Focus mode
When the button is not illuminated ERGO is in Global mode
When you hold the button down for 1 sec ERGO is bypassed, and the LED will flash indicating correction is not used.
Does ERGO use analog or digital volume control?
ERGO uses a digitally controlled analog volume control. This means that the signal to noise ratio of ERGO is constant throughout
the volume setting. This is an expensive method which is far superior to systems that use digital volume control, since digital
volume adjustments actually reduce the signal to noise ratio of the system at lower volumes. ERGO is true and clear throughout
its volume range. The Left to Right matching or balance is also much better than a traditional analog potentiometer.
Does ERGO need external power?
No. If you have a 6-pin or 9-pin Firewire connection ERGO can draw its power directly from the FireWire interface. If using ERGO
in “stand-alone” mode you connect the external power supply provided.
Why does ERGO room correction only affect frequencies below 500Hz?
90% of the main acoustic problems in studio control rooms occur in frequencies below 500Hz. ERGO’s use of RoomPerfect is
designed to specifically correct this area of the freq. spectrum. To fix the remaining 10%, or problems above 500Hz, requires
significantly more processing power because of the timing requirements of processing higher frequency components.
Does ERGO work during tracking, or only during mix down?
ERGO’s room correction should be bypassed during tracking. As with all audio interfaces and processing should be disabled, this
results in the lowest latency when monitoring your performance. After the track is recorded, room correction can be enabled
again.
46

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw KRK Systems Ergo bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van KRK Systems Ergo in de taal/talen: Engels als bijlage per email.

De handleiding is 3,35 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info