657951
28
Verklein
Vergroot
Pagina terug
1/100
Pagina verder
28
ENGLISH
5.2 Lighting the fire
Important!
Please note that if too little wood is used when lighting the fire,
or if the pieces of wood are too large, it will not be possible to
attain the optimum working temperature in the burn chamber.
This can result in poor combustion and may lead to a heavy build-
up of soot, or cause the fire to die out when the door is closed.
If the house has a mechanical ventilation system, the pressure
inside the house is negative and the fireplace does not have an
outside air connection, open a window near to the stove before
lighting a fire. Let the window remain open for a minute or two
until the fire has begun to burn properly.
Fig. 41
Place two medium-sized logs on each side at the bottom of
the burn chamber. NB: In order to avoid a build-up of soot on
the glass, it is important not to let the logs touch the glass.
Place firelighters or bark off the birch wood between the logs.
Stack some finely split wood on top in a criss-cross pattern.
Light the fire.
Fig. 42
A
B
Pull out the ignition vent (A) (the air vent (B) automatically
follows.
5.3 Stoking the fire
Fig. 43
B
To be able to control the heat output, it is important to have
a thick layer of embers and a high temperature in the burn
chamber. Stoke the fire with more wood when it has burned
down to embers. NB: Use a glove or something similar to
protect your hand in case the handles are hot.
Open the door slightly and allow the pressure in the
burn chamber to even out for a few seconds before opening
the door fully. This prevents smoke and ash from spilling out.
Never put on more wood while the fire is burning well.
Stoke with 2 or 3 logs that together weigh about 2 kg. To
ensure optimal combustion, logs must NOT be higher than
the upper holes in the rear plate.
• Close the door.
Leave the ignition vent and the air vent open for 2 or 3 minutes
until the logs have turned black and are burning well. Then
adjust the ignition and air vents to 40% to 70%.
The conditions for controlling combustion vary depending
on the temperature in the burn chamber and the draught
in the chimney.
Important! It is important to get the wood burning quickly and
we therefore recommend that you open up the air supply. Burning
at too low a temperature and with too little air can in some cases
cause gas ignition which may damage the stove.
Refuelling on to a low fire bed: If there is insufficent
burning material in the firebed to light a new fuel charge,
excessive smoke emission can occur. Refilling must be carried
out onto a sufficient quantity of glowing embers and ash
that new fuel charge will ignite in a reasonable period. If
there are too few embers in the fire bed, add suitable kindling
to prevent excessive smoke.
• Fuel overloading: The maximum amount of fuel specified
in this manual should not be exceeded, overloading can
cause exess smoke
Operating with door left open: Operation with the door
open can cause excess smoke. This appliance must not
be operated with the appliance door left open except as
directed in the instructions.
Dampers left open: Operation with the air controls or
apploance dampers can excess smoke. The appliance must
not be operated with air controls, appliance dampers or door
left open exept as directed in the instructions.
28

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Jotul I 520 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Jotul I 520 in de taal/talen: Nederlands, Duits, Engels als bijlage per email.

De handleiding is 7,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info