17
9.0 Optional equipment
9.1 Ash solution with riddling grate (fig. 9)
1. Remove the accumulated ash when needed (fig. 9F). If the
riddling grate is to be used the grate has to be closed when
the fireplace is being used.
2. Remove the grate with the riddler (fig. 9C). Place the
gasket along the rim of the hole. Insert the ash pail mantle
(fig. 10A) for the ash compartment (fig. 10B) and fix to
the bottom plate with 3 screws catching under the burn
chamber. Place the ash compartment.
3. Dissasemble the vent frame (fig. 9A) and exchange the
vent with the predrilled vent (fig. 9B).
4. The lever (fig. 9C) should be fit to the grate link (fig. 9D) by
inserting the Z-shaped tip of th lever into the holde of the
link arm from the underneath.
5. Place the fireplace bottom (fig. 9G), and insert the tapped
tip of the lever through the predrilled vent (fig. 9C).
6. Screw the knob onto the lever.
7. Place the grate with the riddler (Fig. 9 F) in position and be
sure the wart is positioned into the fork of the link.
See «6.2 Ash removal - Use of the Ash Solution».
9.2 Narrow side trim (fig. 4)
Panorama/Harmony
1. Support the front frame in the middle with a wedge
formed tool to prevent it from sinking while being
loosened. A wedge formed screwdriver, or a wooden pencil
will do.
2. Unscrew the two screws (fig. 4F) at one side first. Remove
the two corresponding nuts.
3. Place the side trim and fasten with the same screws.
Note: The trim pieces are symmetric and will fit on either
side. The 4 M6 self thread holes will fit in pairs on each
side.
4. Repeat the same operation at the other side.
5. Remove the wedge.
9.3 Top trim panels
This panel can be used to simplify bricking up at the top of the
fireplace aperture. Locate the front panels at the top.
9.4 Convection chamber - cat. no. 340794
In order to improve heat emission into other rooms, you can
assembly a convection chamber on top of the product. Connect
flexible channels directly from the warm air adapters on the top
of the warming chamber and directly to the vents.
Warm air channels in the fireplace must be of non-flammable
material. The channels can be extremly hot, and it is very important
that these are not in touch with burnable materials.
If a convection chamber is used, do not install a fan that draws
air from the convection chamber. However a fan that provides
pressure in the convection chamber can be installed.
ENGLISH
