Handleiding Jotul F 134 (pagina 21 van 72) (Nederlands, Engels, Frans)

657937

Verklein

Vergroot

Pagina terug

1/72

Pagina verder

4.7 Use

• Push the ignition vent all the way to the left (ﬁ g. 28). Open

the air vent (ﬁ g. 28) by pushing it to the right. (Use a glove,

for example, as the handle can become hot.).

Fig. 29

• Place two medium sized logs in/out on each side of the

base. N.B. In order to avoid sooting on the glass, it is

important that the log is not placed adjacent to the glass

on the product.

• Crumple some newspaper (or birch bark) between these

and add some kindling wood in a criss-cross pattern on top

and light the newspaper.

• Gradually increase the size of the ﬁ re, but the wood should

not be stacked higher than the horizontal holes on the back

burn plate. See ﬁ g. 28 C.

• Finally, place a medium-sized log on the top of the pile.

• Place 2 or 3 briquettes or kindling sticks under the top layer

of kindling and light the ﬁ re.

• NB: The maximum height of the pile of the wood

should be just below the horizontal holes. The holes

must not be covered.

• Check that the afterburning (secondary combustion) starts.

This is best indicated by yellow, ﬂ ickering ﬂ ames under the

bafﬂ e.

• Then regulate the rate of combustion to the desired level of

heating by adjusting the air vent (ﬁ g. 28).

• Close the stove door. It must always be closed when the

ﬁ re is lit.

Adding ﬁ rewood

Stoke the stove frequently but only add small amounts of fuel

at a time. If the stove is ﬁ lled too full, the heat created may

cause extreme stress in the chimney. Add fuel to the ﬁ re in

moderation. Avoid smouldering ﬁ res as this produces the most

pollution. The ﬁ re is best when it is burning well and the smoke

from the chimney is almost invisible.

4.7 Danger of overheating

The ﬁ replace must never be used in a manner that causes

overheating.

Overheating occurs when there is too much fuel and/or too

much air so that too much heat develops. A sure sign of

overheating is when parts of the ﬁ replace glow red. If this

happens, reduce the air vent opening immediately.

Seek professional advice if you suspect that the chimney is

not drawing properly (too much/too little draught). For further

information, see «4.4 Chimney and ﬂ ue pipe»

5.2 Ash removal

Jøtul F 130 has an ash pan which makes it easy to remove the

ashes.

• Only remove ashes when the ﬁ replace is cold.

• Push/pull the handle for the ash grate/ignition vent out and

in several times so that the ashes fall down into the ash

pan. Use something like a glove to grab the handle on the

ash pan.

• Make sure that the ash pan doesn’t ﬁ ll up so high that it

keeps ash from coming through the grate into the pan.

5.0 Daily use

Odours when using the ﬁ replace for the ﬁ rst time

When the ﬁ replace is used for the ﬁ rst time, it may emit an

irritating gas which may smell slightly. This happens because

the paint dries.The gas is not toxic but the room should be

thoroughly ventilated. Let the ﬁ re burn with a high draught

until all traces of the gas have disappeared and no smoke or

odours can be detected.

Heating advice

NB: Logs that have been stored outdoors or in a cold room

should be brought indoors 24 hours before use to bring them

up to room temperature.

There are various ways of heating the stove but it is always

important to be careful about what you put in the stove. See

the section on “Wood quality”.

Wood quality

By quality wood we mean most well-known types of wood such

as birch, spruce and pine.

The logs should be dried so that the moisture content is no

more than 20%.

To achieve this, the logs should be cut during the late winter.

They should be split and stacked in a way that ensures good

ventilation. The wood stacks should be covered to protect the

logs from rain. The logs should be brought indoors during early

autumn and stacked/stored for use in the coming winter.

Be especially careful never to use the following

materials as fuel in your ﬁ replace:

• Household rubbish, plastic bags, etc.

• Painted or impregnated timber (which is extremely toxic).

• Laminated wooden planks.

• Driftwood

These may harm the product and are also pollutants.

NB: Never use petrol, parafﬁ n, methylated spirit or similar

liquids to light the ﬁ re. You may cause serious injury to

yourself and damage to the product.

ENGLISH

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Jotul F 134 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info