Handleiding JVC RX-5040B (pagina 22 van 44) (Engels)

602845

Verklein

Vergroot

Pagina terug

1/44

Pagina verder

Speaker distance—FRONT L DIST, FRONT R DIST,

CENTER DIST, SURR L DIST, SURR R DIST

Set the distance from the listening point within the range of

0.3 m (1 ft) to 9.0 m (30 ft), in 0.3 m (1 ft) intervals.

• When shipped from the factory, distance for each speaker is

set to “3.0 m (10 ft).”

Notes:

• You cannot set the speaker distance for the speakers you have

selected “NONE.”

• For RX-6040B/RX-6042S: This setting is not valid for “DVD

MULTI.”

Ex. In the above case, set the speaker distance as follows:

Front speakers: 3.0 m (10 ft)

Center speaker: 3.0 m (10 ft)

Surround speakers: 2.7 m (9 ft)

Setting the Bass Sounds

You can adjust subwoofer and bass sounds precisely according to

your preference.

Subwoofer output—SUBWOOFER OUT

You can select the type of the signal which can be transmitted

through the subwoofer. In other words, you can determine

whether or not the bass elements of the front speaker channels

are transmitted through the subwoofer regardless of the front

speaker size setting (either “SMALL” or “LARGE”).

Select one of the following:

SWFR LFE: Select to emit only the LFE signals (while

playing Dolby Digital and DTS software) or the

bass elements of the “SMALL” front speakers

(while playing any source other than the above).

SWFR LFE+MAIN: Select to always emit the bass elements of

the front speaker channels (MAIN). While

playing Dolby Digital and DTS software, the

bass element and the LFE signals are both

emitted.

Note:

If you have selected “SUBWOOFER NO” for the subwoofer, this

function is not available.

Setting the Speakers

To obtain the best possible surround effect from the Surround and

DSP modes, register the setting about the speaker arrangement after

all connections are completed.

• If you have used Quick Speaker Setup on page 18, this setting is

not required.

Subwoofer setting—SUBWOOFER

Select whether you have connected a subwoofer or not.

SUBWOOFER YES: Select when a subwoofer is connected.

SUBWOOFER NO: Select when no subwoofer is used.

Note:

If you have selected “SUBWOOFER NO” for the subwoofer, you

cannot use the SUBWOOFER OUT ON/OFF button on the front

panel.

Speaker size—FRNT SPEAKERS, CNTR SPEAKER,

SURR SPEAKERS

Select the size for each connected speaker.

LARGE: Select when the speaker size is relatively large.

SMALL: Select when the speaker size is relatively small.

NONE: Select this when you have not connected a

speaker. (Not selectable for the front speakers)

Notes:

• Keep the following comments in mind as reference when

adjusting.

– If the size of the cone speaker unit built in your speaker is

larger than 12 cm (4

inches), select “LARGE,” and if it is

smaller than 12 cm (4

inches), select “SMALL.”

• If you have selected “SUBWOOFER NO” for the subwoofer

setting, you can only select “LARGE” for the front speakers.

• If you have selected “SMALL” for the front speakers, you cannot

select “LARGE” for the center and surround speakers.

Setting the Speaker Distance

The distance from your listening point to the speakers is another

important element to obtain the best possible sound of the Surround

and DSP modes. Set the distance from your listening point to the

speakers.

By referring to the speaker distance setting, this unit automatically

sets the delay time of the sound through each speaker so that sounds

through all the speakers can reach you with the same timing.

• If you have used Quick Speaker Setup on page 18, this setting is

not required.

Measuring unit—DISTANCE UNIT

Select which measuring unit you use.

UNIT METER: Select to set the distance in meters.

UNIT FEET: Select to set the distance in feet.

Basic Settings

2.1 m

(7 ft)

2.4 m

(8 ft)

2.7 m

(9 ft)

3.0 m

(10 ft)

3.3 m

(11 ft)

18-22_5040&6040[J]f.p65 03.12.18, 15:2320

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

JVC RX-5040B Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van JVC RX-5040B

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info