EN 17
ACTIVATE SCENE FINDER
1
Press SCENE FINDER. The recorder starts forward
search for 5 seconds and then fast-forwards 10 minutes
on the counter. This cycle is repeated until the end of
the tape is reached.
● To start Scene Finder in the reverse direction, press
SCENE FINDER and then turn the SHUTTLE ring to
the left (or press the REW button) within 2 seconds.
This cycle is repeated until the beginning of the tape.
● During Scene Finder, the following indications appear
on the display panel:
STOP SCENE FINDER
2
Press STOP.
NOTES:
●
During Scene Finder search, you can also hear the tape
sound. During fast forward or rewind, you hear the current TV
sound instead.
●
Scene Finder does not function during Index Search.
This function helps you check contents of unlabeled recorded
tapes at the touch of a single button.
NOTE:
Scene Finder cannot be used when the recorder is in the Record
mode.
Scene Finder
10 minutes
on counter
FF REW FF REW FF REW
Search Search Search
5 seconds10 minutes
on counter
5 seconds 5 seconds
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads “0:00:00” (instead of at the beginning of the
tape), press C.MEMORY so that the “M” mark appears before
pressing REW.
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET A/B CODE SWITCH
2
Set to B.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
Some TV sets may malfunction in response to the B mode. If
this happens, switch back to the A mode.
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C. (COUNTER) RESET during playback at a point
you wish to locate later. The counter reads “0:00:00”.
Then press C.MEMORY, and “M” appears in front of the
counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
● The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
● To cancel Counter Memory, press C.MEMORY again.
