39850
12
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
EN
12
20
5
m
h
1h30m
1h29m
0h03m
1h30m
0h02m
0h01m
0h00m
P
L
A
Y
O
F
F
A
M
S
H
U
T
T
L
E
S
E
A
R
C
H
0
!
@
$
180°
90°
t
Q
5
During shooting
Basic Recording
Perform the procedures listed below before continuing.
Power ( pg. 7)
Grip Adjustment ( pg. 8)
Viewfinder Adjustment ( pg. 8)
Load A Cassette ( pg. 9)
Recording Mode Setting ( pg. 10)
1 Remove the lens cap.
Pull on bottom end Q of LCD monitor to open and set
the VIDEO/MEMORY Switch t to VIDEO.
2 Set the Power Switch @ to or while
pressing down the Lock Button $ located on the
switch.
Shooting while using the LCD monitor: Open the
LCD monitor fully.
Shooting while using the viewfinder: Pull out the
viewfinder fully.
The Power lamp 0 lights and the camcorder enters
the Record-Standby mode. PAUSE 8 is displayed.
The image will not appear simultaneously on the LCD
monitor and the viewfinder. See PRIORITY in the
SYSTEM Menu ( pg. 34).
3 Press the Recording Start/Stop Button !.
4, 8 appears and the tally lamp ^ lights while
recording is in progress.
To Stop Recording, press the Recording Start/Stop
Button !. The camcorder re-enters the Record-
Standby mode.
To Adjust The Brightness Of The Display
..... press MONITOR BRIGHT + or 5 until the bright
level indicator o on the display moves and the
appropriate brightness is reached.
It is also possible to adjust the brightness of the
viewfinder. Pull out the viewfinder, set PRIORITY in
the SYSTEM Menu to FINDER ( pg. 34) and
adjust as described above.
TAPE RECORDING
NOTES:
If the Record-Standby mode continues for 5 minutes, the
camcorders power shuts off automatically. To turn the
camcorder on again, push back and pull out the
viewfinder again or close and re-open the LCD monitor.
When a blank portion is left between recorded scenes on
the tape, the time code is interrupted and errors may
occur when editing the tape. To avoid this, refer to
RECORDING FROM THE MIDDLE OF A TAPE
(
pg. 14).
To turn the tally lamp
^ or beep sounds off,
pg. 34.
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
Black spots or bright spots of light (red, green or blue)
may appear constantly on the LCD monitor or the
viewfinder (
pg. 47).
When the Recording Start/Stop button ! is pressed, it
may take a few seconds before actual recording starts.
4 starts rotating when the camcorder actually
starts recording.
The time required to calculate and display the remaining
tape length, and the accuracy of the calculation, may vary
according to the type of tape used.
TAPE END appears when the tape reaches its end, and
the power goes off automatically if left in this condition for
5 minutes. TAPE END also appears when a cassette at
its end is loaded.
Tape remaining time
indicator (Approximate)
Display
(Now calculating)
(Blinking)
(Blinking)
(Blinking)
01 DX300/100/95/75EK_EN 12-16 2/26/03, 7:12 PM12
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JVC GR-DX95 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JVC GR-DX95 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,72 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van JVC GR-DX95

JVC GR-DX95 Gebruiksaanwijzing - Nederlands - 60 pagina's

JVC GR-DX95 Gebruiksaanwijzing - Nederlands - 60 pagina's

JVC GR-DX95 Gebruiksaanwijzing - Deutsch - 60 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info