GLID 126
Note about Mixings 1 and 3:
1. When the slave channel is aileron, its mixing operation is
effected with preset differential.
2. When the slave channel is flap, its mixing operation is
effected to preset flap to aileron mixing (2 steps mixing).
Note about Mixing 2 and 4:
When the master channel is spoiler, its operation is included in
spoiler trim operations.
Note about Mixings 5 and 6:
1. When the master channel is aileron, elevator or rudder, the
trims are functional for the Master and Slave channels.
2. Mixes 5 and 6 incorporate include mixing.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Master channel
Present stick
position
Point to be adjusted
Mixing value (maximum
±
100)
Mixing switch
Mixing value at
present stick
position
Slave channel
Channel indicator
SPOI: Spoiler
AILE: Aileron
ELEV: Elevator
RUDD: Rudder
POT 5: Right Aileron
POT 6: Flap
AUX2: Right Flap
AUX3: Extra Channel (AUX3)
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
Press to reset value at
cursor to factory preset
position/value, or to
inhibit mixing
To Programmable
Mixing (2-6)
To Trim Offset
function
Press to select
channels to be
mixed, and to
move cursor on
graph to points to
be adjusted
Press either the +
or - key to activate
the mixing
function, to
increase/decrease
values, and to
change the EXP
function from OFF
to ON
Press to move
the cursor at
left of screen
4.14 Programmable Mixing (1-6), cont.
Assigning Channels
Using the SEL key, move the cursor to the left of the master
channel. Press the left or right CH keys to position the cursor
below the master or slave channel. Press the + or - keys to select
the desired channels.
Operating with a Switch
Pressing the SEL key, position the cursor to the side of SW: and
using the + or - keys select the desired switch for the particular
program mix being used. Refer to figure 4.13B.
Assigning Mixing Values
Position the cursor to the left of “Point” and press the left or right
CH keys to reverse the position point. Increase or decrease the
mixing value using the + or - keys or the CLR key. When you
wish to reverse the mixing direction, press the - key to increase
the minus value to the desired position. To activate point 1 or 3
with “INH” displayed, press the + or - key at that position to
display mixing value. Press the CLR key if you want to inhibit
mixing. Mixing value “0” can be set at points L, 2, and H by
pressing the CLR key.
