4.6 Aileron to Flap Mixing (Function Mode)
The Aileron to Flap Mixing Function is only applicable when the
Dual Flap Function is activated in the Model Set-Up Mode. For
information on how to activate the Dual Flap Function, refer to
the Wing Type Selection Function.
The purpose of this mixing function is to mix the ailerons with the
flaps so the the flaps will operate in conjunction with the
ailerons. In effect, this will increase the amount of aileron control
surface area available. The amount of mix is adjustable; thus
you can tailor the aileron response to fit your flying style. The
knob on the upper left corner of the XP8103 transmitter will trim
the flaps as ailerons. This knob will trim the flaps as ailerons. The
aileron ratchet trim has no effect on the flaps.
In Function Mode, use the UP and DN keys to select Aileron to
Flap Mixing and access by pressing the UP and DN keys
simultaneously.
Note: If differential mixing is being used, the flaps will also
operate differently according to the value input in the differential
mixing.
Selection of Operational Switch
Switches for these mixing functions are listed below and can be
accessed with the + or - keys. When applicable switch is in the
OFF position, SW OFF flashes and increase or decrease mixing
value is not applicable. Press the Clear key to set ON.
GLID 116
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
SW OFF appears when the flap
mixing is in the middle of lower
position
Elevator Operating Direction
(D=Down, U=Up)
Indicates the function
selected
Elevator to Flap Mixing Value (Range
± 125%)
Indicates current mixing switch
activated:
ON: Always ON
MIX: Mixing Switch
FLP-D: ON when Flap Switch is in
lower position
FLP-U: ON when Flap Switch is in
upper position
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
Press the + or - key to
adjust the UP and DN
Mixing Values or to
select the active Mixing
Switch
Press either CH
key to select
function:
↓
Rate
↓
SW
Press to return the
Mixing Value to
zero or to return
the active Mixing
Switch to ON
