10X MANUAL Heli
7
Antenna
• The adjustable base can be locked into position by tighten-
ing the two screws just to the rear of the antenna ball mount. Do
not over-tighten. This feature allows you to determine the antenna
angle that suits you best and to lock it in place.
• The antenna can be removed and stored in the special com-
partment in the right side panel of the transmitter. The next time
you fly, simply thread the antenna into the ball mount. It will
automatically assume the previously set angle.
Note: Do not point your antenna directly at your model heli-
copter. The tip of the antenna is the weakest radio frequency
radiator in any radio controlled transmitter. Instead, have the
antenna at about a 20°– 45° angle away from the model.
For a proper range test of the
PCM10X system please refer to
Section 13, Daily Flight Chec
ks.
Transmitter Controls
3
3.1
Control Identification
Swiveling Antenna
Tilting Antenna Base
Power Pilot Lamp
RF Output Lamp
AUX-4 Knob
Hovering Throttle Knob
High Pitch Trim Lever
Audible Speaker
Aileron Dual Rate Switch
Aileron/Elevator Stick
Digital Aileron Trim
Antenna Storage
Digital Elevator Trim
LCD Touch Panel Display
On/Off Power Switch
Neck Strap Eyelet
Mechanical Throttle Trim
Digital Rudder Trim
Throttle/Rudder Stick
Hovering Pitch Knob
Gear Switch
AUX-5 Knob
Low Pitch Trim Lever
Flight Mode Switch
Carrying Handle
Elevator Dual Rate Switch
Mix Switch
