XR650-CSi SPECIFICATIONS:
Woofers: Mineral-filled polypropylene cone body,
1-inch (25mm) voice coil, low-profile/ symmetrical-
roll spider, butyl rubber surround.
Tweeters: 1-inch (25 mm) aluminum dome tweeter
with soft, rubber suspension,
neodymium magnet, ferrofluid cooled and damped.
Variable mounting system with swivel/
rotation capability.
Crossover Networks: 2-way network with 1st
order low-pass and 2nd order high-pass circuit.
Premium polypropylene film capacitors and air-core
inductors. 5-position adjustable tweeter output
level. 3-position midrange presence control.
Polyswitch tweeter protection.
Continuous Power Handling:
70 Watts (RMS Method)
Frequency Response: 48 Hz - 25 KHz (± 3 dB)
Efficiency @ 1W/1m: 89.5 dB
Nominal Impedance: 4 ohms
Included Components and Parts:
• Two XR650-CW 6.50-inch (160 mm) woofers
• Two XR100-CT 1-inch (25 mm) tweeters
• Two XR650-CSxo 2-Way Crossover networks
• Two Flush-Mount tweeter fixtures with metal
spring clips and optional trim rings
• Two Surface-Mount tweeter fixtures
• Two Metal Woofer Grilles and Grille Trays
• Butyl adhesive putty for woofer grilles
• Twelve #8 x 1 1/4-inch (30 mm)
sheet metal screws
• Four #6 x 5/8-inch (16 mm) sheet metal screws
• Two 1-inch (25 mm) machine screws
• Eight Mounting Clips
• Two 6.4 mm female crimpable connectors
• Two 4.7 mm female crimpable connectors
• Four 2.8 mm male crimpable connectors
• Twelve crimpable spade connectors
• Four black nylon wire ties
GETTING STARTED:
• Turn off the audio system. It is also advisable to
disconnect the negative (-) terminal of your
vehicle’s battery whenever performing
installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the
vehicle, many vehicles are not symmetrical!
• Always wear protective eyewear.
WARNING!
It is absolutely vital that your component
system is connected as shown in the diagrams
below. Failure to connect the system as
shown will result in damage to your speakers
which is NOT covered under warranty.
Do not substitute different crossover networks
into your XR650-CSi System. Only use crossover
networks clearly marked “XR650/570-CSpxo”.
2 JL AUDIO XR650-CSi