700493
13
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
13
“Filter Freq.” setting. The “24dB” setting engages
a sharper filter slope that more aggressively
attenuates frequencies above the selected “Filter
Freq.” setting. Neither setting is inherently
better”, but in general, the shallower “12dB
setting is more desirable for a subwoofer having to
interface with smaller main speakers (6.5-inch or
smaller). The sharper “24dB” setting is typically
better when interfacing with larger main speakers,
like our 7.7-inch components and coaxials.
Experiment to find the slope setting that results in
the smoothest subwoofer to midbass transition.
Next, turn your attention to the CH 3 &
4 Controls and select BP (bandpass) on
the “Filter Mode switch. A bandpass filter is
actually composed of two filters (one high-pass
and one low-pass), which in combination allow a
defined “band” of frequencies to pass through the
amplifier channels and onto the speakers. These
are ideal for actively filtered mid-bass or mid-
range speakers in automotive sound systems.
Now that you have engaged Bandpass Mode
for Channels 3 & 4, select an appropriate Filter
Freq. (again, 80 Hz is a good starting point).
The Filter Frequency you are adjusting with this
control is the high-pass portion of the bandpass
filter. The low-pass portion is automatically set by
the tweeter channels “Filter Freq.” adjustment
(CH 1 & 2). The low-pass portion of the bandpass
filter will always track with the CH 1 & 2 “Filter
Freq.” setting.
Finally, turn your attention to the CH 1
& 2 Controls and select x10 (high-pass)
on the “HP Filter Mode switch. This switch
position multiplies the indicated “Filter
Freq.” value by a factor of 10, so that an
indicated frequency of 500 Hz is actually a
filter frequency of 5000 Hz (5 kHz). The filter
slope for this section is fixed at 12dB/octave.
Now, select an appropriate Filter Freq.” for
your tweeters (5000 Hz is a good starting point).
Before attempting any lower frequency settings,
consult the documentation for the tweeters you
are using and make sure you will not be driving
the tweeters with frequencies lower than they are
designed to handle. JL Audio mobile component
tweeters should not be operated with Filter
Frequencies lower than 3 kHz.
After proper adjustment of the “Input
Sens.” controls for both main channel
pairs and the subwoofer channel using the
method shown in Appendix A (page 14),
you can fine tune filter frequencies and
attenuate either pair of channels to achieve
proper balance. For precise filter frequency
information refer to Appendix B (page 15)
To operate two M700/5’s in Tri-Amplified
mode (one for left channel and the other for right
channel), set the “Input Mode” switches of both
amplifiers in “2 Ch.” mode, and apply the left
channel signal to both the left and right inputs of
the first amplifier’s Channel 1 & 2 Inputs, using
an RCA y-adaptor with one female and two male
ends. Then apply the right channel signal to both
the left and right inputs of the second amplifiers
Channel 1 & 2 inputs, using a second RCA
y-adaptor with one female and two male ends.
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JL Audio M700 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JL Audio M700 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,48 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info