- 29 -
ENGLISH
ASSEMBLY
CASING
The stove is delivered with metallic sides (A-B) and the metal-
lic brackets for • xing the ceramic side elements (D) already
• tted. The pieces indicated below are packaged separately.
• 4 ceramic front side elements (C)
• 1 ceramic top insert (E)
• 2 dowels for the ceramic top insert (F)
• 8 M4 screws with milled heads (X)
• 8 washers Ø 4
To • t proceed as follows:
Fig. 1/2/3
Remove the two metallic brackets • xing the stove's ceramic side ele-
ments (D) by sliding them from the bottom upwards, about 3 cm.
Apply metallic brackets (D) onto the back of the ceramic front
side elements (C), • xing them into the holes provided using the
M4 screws and the washers
Ø 4
(provided).
Fig. 3/4
Fit the ceramic sides elements (C) (complete with metallic
brackets) from above moving them downwards into the slot (L)
on the square elements of the metallic side (M).
Fig. 5/6/7
Check the vertical alignment of the ceramic side elements (C)
and make any necessary adjustments with the screws above the
top (V - • g. 5) and inside the stove with the screws (R - • g. 6/7)
N.B. Before carrying out this operation, remove the galva-
nised panel (Z - ! g. 6/7) on both sides and loosen the locking
screws (T - ! g. 6/7).
Fig. 4/8
Apply the two dowels (F) onto the lower side of the ceramic top
insert (E), screwing them into the holes provided.
Position the ceramic top insert, • tting the dowels into the holes
(S) provided on the metallic brackets (D) installed previously.