8
Setting up the Anemometer (wind sensor)
1. Assemble the wind cups and wind vane to the anemometer arm
2. Attach the assembled anemometer to the base.
3. Insert two 2 x UM-3 or “AA” size 1.5V batteries into the battery holder in the base.
4. Mount the anemometer onto a vertical surface, using the ttings provided.
5. To allow the main console unit to nd the direction which the wind vane is oriented, the
following procedures are required:
i. Insert the batteries
ii. Point the wind vane towards the north. Use a compass or map if necessary.
iii. Use a pin to press the “SET” key which is in the battery compartment of the wind
sensor.
Note: Above procedure must be repeated for changing battery.
The “SET” will toggle the direction between two mode:
1. Let the wind direction as manufacturer design. It will be as a default setting after
2. Set the current direction as NORTH.
Placement tips:
- Check that wind can travel freely around the anemometer and is not distorted by nearby
buildings, trees or other structures.
- For better results, place the anemometer at least 3m above local structures and
obstacles. The ground creates a frictional effect to wind ow and will attenuate readings.
- Aim for maximum exposure of the anemometer to the commonest wind directions in
your area.
- The ofcial mounting location for anemometers is 10m (33 ft) above ground level in a
clear unobstructed location.
Setting up the Main Console Unit
1. Open the latch at the back of the main console unit.
2. Insert 4 x UM-3 or “AA” size 1.5V batteries according to the polarities shown.
3. Reattach the latch.
4. You are highly recommended to connect the AC/DC adaptor. For the feathure of the
automatic backlight control function, the AC/DC adaptor must be used.
5. If placing the console unit on a table or horizontal surface, fold out the table stand and
adjust to the optimal viewing angle.
6. If mounting the console unit on a wall or vertical surface, fold the table stand back into
the unit and use the tting provided.
