578588

Irox CELEBRATION-66 Handleiding

2
Verklein
Vergroot
Pagina terug
1/3
Pagina verder
4. EXTENDED OPERATION
All operations on the device are carried out by pressing buttons.
It is very important that you read chapters 2 and 3!
In these chapters you will find additional information about the functions
4.1 Weather forecasts
This Irox device uses a high quality pressure sensor to measure barometric pressure and the
respective changes. This information is then, using a by meteorologists specially developed
algorithm, used to calculate a weather forecast for the coming 12-24 hrs. Five different
forecasts are possible:
COMMENT: These calculated weather forecasts have a reliability of approx. 70%.
The forecast for the coming 12-24 hrs is displayed, not the current weather. SUNNY
means clear weather day and night.
Slightly cloudy
Cloudy
Rain
Sunny
Heavy rain
RADIO CONTROLLED CLOCK RECEIVING LOGIC
1. As described in chapter 3 the time transmitted by the time signal transmitter DCF77 is
automatically received when the batteries are activated. The time signal reception takes
about 3-10 minutes. During receiving the icon will blink, if reception is good with
waves if reception is poor without.
2. If you would like to switch the automatic time reception off and then on again you can do
so with the time-setting (see below "Setting").
3. During normal operation an automatic time reception will be activated daily at 0:00 and
4:00. If the reception at 4:00 failed, another reception will start at 5:00.
4. As soon as the device has received a signal the time will be correctly adjusted and the
icon is active.
5. If reception is poor the icon will be displayed. You may then set the reception to OFF
and adjust the clock manually (see below "Setting"). If you leave the reception On, a
next reception attempt will then be activated during the night.
SETTING
You can choose between two operating modes for the clock:
1- Radio controlled clock with regular time comparisons. In between the active receptions
the time runs on integrated quartz (this is a factory setting which is reactivated after every
battery replacement)
2- Strictly as a quartz clock
Move to set mode with the set button (press and hold for 3 seconds). On will appear in the
time display. This means the radio receiving is activated.
With the ▲/▼ buttons you can make changes to the setting, with the set button you move to
the next setting.
The setting options vary depending on operating mode On or OFF
4.4 Target Date (Event) and Countdown
You can enter the time of one event with year, month, day and hour and in addition a
corresponding text with up to 15 letters.
CELEBRATION will then countdown the days, hours, minutes and seconds from the set
time to the beginning of the event (COUNTDOWN).
If the event takes place in a different time zone it is very important that you calculate the
time difference. If for example admittance to an event is at 17:00 in London, then it is
already 18:00 in Central Europe! If then for example you live in Germany or Switzerland
you must enter 18:00 as start time!
When programming an event consider following questions:
- In which time zone is the event taking place?
- In which time zone do you live and what time is it on your display?
- Is daylight savings time (summer/winter) of importance?
You can enter a target date up to the year 2099. The countdown display is limited to
maximum 3999 days (this means an event that is over ten years from "now"!). If you select
a date beyond these 3999 days the clock will still count the time down but only in the
background. The depicted 3999 days, 23 hours, 59 minutes and 59 seconds remains the
same until the countdown is below this number.
Caution: During the setting procedure as described below you will exit the setting mode if
more than 1 minute passes between pressing the buttons. The settings already made up to
this point will be taken over.
SETTING
Press and hold the event set button until TARGET DAY SET appears in window B and the
year (YEAR) blinks.
You can adjust the setting with the ▲/▼ buttons, use the set button to move to the next
setting:
Month Day Hour Text for the event (in window C !).
The letters for the text line are also selected using the ▲/▼ button, to move to the next
character use the set button. You can also use the event set button to move back in the
text. Maximum 15 characters can be entered.
Selection of characters: A-Z, 0-9, Space and special characters / + * '
Setting is complete when the last character in window C has been confirmed by pressing the
set button or if when entering the text the set button is pressed and held for 3 seconds.
WHAT HAPPENS WHEN THE COUNTDOWN IS COMPLETED ?
When the countdown reaches zero the time of the event has arrived.
All zeros of the TARGET DAY and the event text display will blink (if the ticker was
activated it will stop). All buttons are now blocked with the exception of the event set
button.
By pressing the event set button you can acknowledge this message and the display that was
active prior to the end of the countdown will appear.
In window B End will now appear for COUNTDOWN and TARGET DAY.
This status will remain until midnight. At midnight the event will be deleted.
It is possible though to program a new event before midnight.
4.5 Moon phase
In steps of 3 days, the current moon phase is displayed by the following icons (the dark part
is same as with the moon: dark !)
Operating mode 1 – Radio controlled clock on = On
- Time indication format: 24 hours or 12 hours resp. AM/PM
- Language selection of the weekday display of the programmed event
- Time zone setting (standard =0, adjustable from -9 to +9 hours):
Time deviation as compared with the received radio time as the respectively valid time in
Central Europe (Germany, France, Switzerland, Denmark etc.). If you set a time zone
“ZONE” and the accordingly corrected time will appear on the time display. This is ideal
for locations where the DCF77 time signal is received but that have a different time such
as Great Britain (-1HR) or Finland (+1HR)
Complete the setting with the set button
If the radio reception was reactivated (switching from OFF to On), the time signal will
also be newly received after exiting the set mode.
Operating mode 2 – Radio controlled clock off = OFF
- Time indication format: 24 hours or 12 hours resp. AM/PM
- Language selection of the weekday display of the programmed event
- Setting the hours
- Setting the minutes
- Setting the date
We recommend this operating mode for locations where the time signal can not be
received. Switching off the receiver spares the batteries.
To the language selection for the event day:
There are a total of 19 languages available. In a predetermined language block of 3
languages the weekday of the programmed event is displayed with a 3 letter abbreviation
of the weekday.
The language blocks contain following 3 languages:
Deutsch – Français- Italiano
English – Espanol – Portugues
Danske/Norske – Svenska – Islenska
Nederlands – Suomalainen – Polski
Cesky – Slovencina – Magyar
Ruski – Srpski – Hrvatski (Russian and Serbian are depicted Cyrillic)
4.2 Temperature / Moisture
The display unit measures the temperature and relative humidity of its location. The
temperature is displayed in °C.
4.3 Time function
The time signal DCF 77 is transmitted by the atomic clock in Mainflingen near
Frankfurt/Main. The long-wave transmitter has a range of up to 1500 km.
If the time icon is displayed without waves you have reception problems. Please
observe following points:
- There are fewer disturbances in the atmosphere during the night which increases the
likeliness of reception. One reception per day is completely sufficient to ensure the
preciseness of the clock by +/- 1 second
- Make sure that the device is at least 2 meters (8 feet) away from possible sources of
disturbance such as TV, computer, monitor, microwave etc.
- In rooms with concrete or metal walls (e.g. cellar rooms, modern office buildings etc.) the
receipt of the signal may be more difficult due to the shielding. In such cases find a better
location for the device near a window. Sometimes it also helps to simply turn the device
by 90°, thereby improving the alignment of the receiving antenna.
Caution: During the setting procedure as described below you will exit the setting mode if
more than 1 minute passes between pressing the buttons. The settings already made up to
this point will be taken over.
Where?
Display unit
Radio controlled
clock does not
receive signal
Symptom Solution
5. TROUBLESHOOTING
If you notice a malfunction of your device, always first check the battery please. If in doubt,
always replace the batteries !
Also please check the following before contacting the customer service of the store where
you purchased the device:
6. BATTERY CHANGE
The batteries last for about 8-12 months. Depending on the batteries used this time frame
may be a bit shorter or longer. A message icon will appear in window C to prevent an
undesired and unexpected interruption of operation.
- IN LOW BATTERY
This means that the batteries in the display unit are becoming too weak and must be
replaced.
The ticker is automatically activated if a battery status message is activated. It is not possible
to stop the ticker as long as the message is displayed!
Important:
Use only new batteries and never combine old batteries with new batteries. Observe polarity
when inserting batteries!
Please also remember that used batteries do not belong in domestic trash, they should be
disposed of at designated collection points. Our environment will appreciate it!
Important note on batteries
• Never use rechargeable batteries. The output of rechargeable batteries is often not
sufficient for our devices.
Reposition the device. Preferably near a
window and leave it there overnight. Perhaps
an additional turning of the device by 90°
would help.
New
Moon
Waxing
Crescent
First
Quarter
Waxing
Gibbous
Full
Moon
Waning
Gibbous
Last
Quarter
Waning
Crescent
2827
3029
3231
3433
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Irox CELEBRATION-66 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Irox CELEBRATION-66 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Irox CELEBRATION-66

Irox CELEBRATION-66 Gebruiksaanwijzing - Deutsch - 3 pagina's

Irox CELEBRATION-66 Gebruiksaanwijzing - Français - 3 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info