694976
18
Verklein
Vergroot
Pagina terug
1/40
Pagina verder
installation instructions
7
problems & solutions
8
Safety during use is only guaranteed if the assembly has taken place in a technically correct way and in accordance with this
installation instruction. The installer is liable for damage caused by an incorrect assembly.
The cooker falls under protective class I and may only be used in combination with an earthed connection. The manufacturer
is not liable for unsuitable operation and possible damage caused by unsuitable electric installations.
The cooker must be connected to a permanent installation in which provisions for switching off are integrated, in accordance
with the installation instructions.
Make sure that the power supply cable does not get jammed during installation or is running along sharp edges. If an oven is
installed below it, make sure the cable runs via the rear corners of the oven to the connection box. It must be placed in such a
way that no contact is made with hot parts of the cooker or oven.
The connection point, socket and/or plug must always be accessible.
The worktop on which the cooker is placed must be flat, horizontal and stable. Observe the instructions from the manufacturer
of the worktop.
In case of incorrect installation or connection, the warranty becomes invalid.
• Attention: any change within the appliance, including replacement of the power supply cable, must be performed by an
authorised installer.
Sufficient space around the cooker is required for safe use. Check that this space is available.
The distance from the cooker to an extraction hood should be at least 650 mm.
ELECTRICAL CONNECTION
Caution: this cooker is always supplied with a cord and plug. The connection is a 1 phase connection.
Check that the voltage corresponds with what is stated on the information plate.
Connect the cooker to an earthed socket.
Caution: The connection point should always be within reach.
Problems Checkpoints and solutions
After inserting the plug in the socket and switching
on the induction cooker with the [ ON/STANDBY ]
key, the [ ON/STANDBY ]
indicator on the display does not light up.
• Is the plug properly inserted in the socket?
• Has the socket, fuse or cord been damaged?
The induction cooker makes a lot of noise.
The electronics of the induction cooker require cooling. It is normal for
the fan to make noise.
Error message
E0 No pan or no suitable pan has been placed.
E1 Temperature sensor defective. Contact customer service.
E2 Operating panel defective. Contact customer service.
E3 Voltage too high. Have your connection checked by an electrician.
E4 Voltage too low. Have your connection checked by an electrician.
E5
The operating panel is overheated. Switch off the cooker and wait until
it is cooled down.
E6
The cooker is overheated and switched off automatically. Check the
ventilation openings and allow the cooker to cool down. The induction
cooker will function normally again.
18 English
VKI3010ZWA-instructions.indd 18 13-9-2018 09:25:05
18

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Inventum VKI 3010 ZWA bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Inventum VKI 3010 ZWA in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 1,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info