551576
21
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
MOUNTING AGAINST THE WALL
Attention: the cooker hood should be mounted onto a flat perpendicular kitchen wall.
Use the provided screws and plugs for mounting against the wall.
Measure the right height for the cooker hood (min. 65/75 cm) and mark the underside of the cooker hood on the wall.
Open the glass visor gently by pulling it towards you.
Remove the grease filters to expose the interior of the cooker hood. A keyhole slot (A) and a retainer hole (B) will be visible on
either side of the back panel.
Hold the cooker hood level against the wall on the correct height according to the marking and mark the holes (A+B) on the wall.
Drill the holes with a masonry drill off Ø8mm at the top of each marked slot and push in a rawl plug in each hole.
Partly insert two screws in the plugs, with a head diameter slightly smaller than the lower opening in the keyhole slot. Leave
about 5 mm of the screw sticking out.
Lift the cooker hood and slide the keyhole slots over the two screws.
Mark the two lower retainer holes and lift the cooker hood down.
Drill the holes with a masonry drill of Ø8mm and insert the plugs.
Mount the cooker hood and place the screws in the retainer holes. Tighten all four screws.
Replace the grease filters.
Place an exhaust-air pipe when you have chosen a duct as the extraction system.
Plug in the appliance.
MOUNTING BELOW A KITCHEN CUPBOARD
Attention: if the cooker hood it to be mounted underneath a cupboard, also take the minimum height (min. 65/75 cm) into
account. Use the provided bolts, nuts and washers for mounting underneath the cupboard.
Advice: Use the provided drilling template to mark the necessary holes for the bolts and for the hole of the exhaust when
connecting the cooker hood to a duct.
Open the glass visor by pulling it gently towards you.
Remove the grease filters to expose the interior of the cooker hood.
Hold the cooker hood underneath the cupboard and mark the four retainer holes (B) and mounting aid holes (A) at the bottom
of the cupboard.
Tape the drilling template to the bottom of the cupboard aligned with the marked positions and draw the hole for the power
cord and the exhaust pipe (C).
ø 120
90
545
35
225
112,5
42
16
70
ø 120
543
260
92
150
A A
B B
C
ø 120
90
545
35
225
112,5
42
16
70
ø 120
543
260
92
150
A A
B B
C
B B
English 21
AKO6001-AKO6002-instructions.indd 21 27-8-2014 11:16:44
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Inventum AKO6002 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Inventum AKO6002 in de taal/talen: Nederlands, Engels als bijlage per email.

De handleiding is 1,14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info