771741
23
Verklein
Vergroot
Pagina terug
1/140
Pagina verder
Page 23
8
Wiring
Safety Precautions
Outdoor Unit Wiring
WARNING
Be sure to disconnect the power supply before
working on the unit.
All electrical wiring must be done according to
local and national regulations.
Electrical wiring must be done by a qualied
technician. Improper connections may cause
electrical malfunction, injury and re.
An independent circuit and single outlet must
be used for this unit. DO NOT plug another
appliance or charger into the same outlet.lf the
electrical circuit capacity is not enough or there
is a defect in the electrical work, it can lead to
shock, re, unit and property damage.
Connect the power cable to the terminals and
fasten it with a clamp. An insecure connection
may cause re.
Make sure that all wiring is done correctly and
the control board cover is properly installed.
Failure to do so can cause overheating at the
connection points, re, and electrical shock.
Ensure that main supply connection is made
through a switch that disconnects all poles, with
contact gap of a least 3mm (0.118”).
DO NOT modify the length of the power cord
or use an extension cord.
WARNING
Before performing any electrical or wiring
work, turn o the main power to the system.
CAUTION
Connect the outdoor wires before connecting
the indoor wires.
Make sure you ground the unit. The ground-
ing wire should be away from gas pipes, wa-
ter pipes, lightning rods, telephone or other
grounding wires. Improper grounding may
cause electrical shock.
DO NOT connect the unit with the power source
until all wiring and piping is completed.
Make sure that you do not cross your electrical
wiring with your signal wiring, as this can cause
distortion and interference.
Follow these instructions to prevent distortion
when the compressor starts:
The unit must be connected to the main
outlet. Normally, the power supply must
have a low output impedance of 32 ohms.
No other equipment should be connected
to the same power circuit.
The unit’s power information can be found
on the rating sticker on the product.
TAKE NOTE OF FUSE SPECIFICATIONS
The air conditioner’s circuit board(PCB) is
designed with a fuse to provide overcurrent
protection. The specications of the fuse are
printed on the circuit board, such as:
Indoor unit: T5A/250VAC,T10A/250VAC. (ap-
plicable for unit adopts R32 refrigerant)
Outdoor unit: T20A/250VAC(for <24000Btu/h
unit),T30A/250VAC(for >24000Btu/h unit)
NOTE: The fuse is made of ceramic.
1. Prepare the cable for connection
a. You must first choose the right cable size
before preparing it for connection. Be sure
to use H07RN-F cables.
Table 8.1: Minimum Cross-Sectional Area of
Power and Signal Cables North America
Rated Current of Appliance (A) AWG
<7 18
7-13 16
13-18 14
18-25 12
25-30 10
23

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Inventor V6MKI32-WiFi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Inventor V6MKI32-WiFi in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 22.17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Inventor V6MKI32-WiFi

Inventor V6MKI32-WiFi Gebruiksaanwijzing - Deutsch, English - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info